Lines Matching +full:bias +full:- +full:pulldown

1 // SPDX-License-Identifier: (GPL-2.0 OR MIT)
6 /dts-v1/;
7 #include "mt8183-kukui.dtsi"
8 #include "mt8183-kukui-audio-ts3a227e-max98357a.dtsi"
11 	ppvarn_lcd: ppvarn-lcd {
12 		compatible = "regulator-fixed";
13 		regulator-name = "ppvarn_lcd";
14 		pinctrl-names = "default";
15 		pinctrl-0 = <&ppvarn_lcd_en>;
17 		enable-active-high;
22 	ppvarp_lcd: ppvarp-lcd {
23 		compatible = "regulator-fixed";
24 		regulator-name = "ppvarp_lcd";
25 		pinctrl-names = "default";
26 		pinctrl-0 = <&ppvarp_lcd_en>;
28 		enable-active-high;
33 	pp1800_lcd: pp1800-lcd {
34 		compatible = "regulator-fixed";
35 		regulator-name = "pp1800_lcd";
36 		pinctrl-names = "default";
37 		pinctrl-0 = <&pp1800_lcd_en>;
39 		enable-active-high;
49 		compatible = "hid-over-i2c";
51 		interrupts-extended = <&pio 155 IRQ_TYPE_LEVEL_LOW>;
52 		pinctrl-names = "default";
53 		pinctrl-0 = <&touch_default>;
55 		post-power-on-delay-ms = <10>;
56 		hid-descr-addr = <0x0001>;
61         pinctrl-names = "default";
62 	pinctrl-0 = <&i2c2_pins>;
64 	clock-frequency = <400000>;
65 	vbus-supply = <&mt6358_vcamio_reg>;
71 		vcc-supply = <&mt6358_vcamio_reg>;
76         pinctrl-names = "default";
77 	pinctrl-0 = <&i2c4_pins>;
79 	clock-frequency = <400000>;
80 	vbus-supply = <&mt6358_vcn18_reg>;
86 		vcc-supply = <&mt6358_vcn18_reg>;
91 	regulator-min-microvolt = <2800000>;
92 	regulator-max-microvolt = <2800000>;
97 	gpio-line-names =
295 	ppvarp_lcd_en: ppvarp-lcd-en {
298 			output-low;
302 	ppvarn_lcd_en: ppvarn-lcd-en {
305 			output-low;
309 	pp1800_lcd_en: pp1800-lcd-en {
312 			output-low;
319 			input-enable;
320 			bias-pull-up;
328 			 * this reset line.  By specifying output-high here
330 			 * pulldown at boot (which makes sure the controller was in
334 			 * "output-high" here.
336 			output-high;
343 		compatible = "google,cros-cbas";
346 	keyboard-controller {
347 		compatible = "google,cros-ec-keyb-switches";
352 	qcom,ath10k-calibration-variant = "GO_KODAMA";
356         google,remote-bus = <2>;