Lines Matching +full:tpm_tis +full:- +full:spi
1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 #include <dt-bindings/gpio/gpio.h>
7 #include <dt-bindings/leds/common.h>
8 #include <dt-bindings/phy/phy-imx8-pcie.h>
12 compatible = "gpio-usb-b-connector", "usb-b-connector";
13 pinctrl-names = "default";
14 pinctrl-0 = <&pinctrl_usbcon1>;
16 label = "Type-C";
17 id-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
21 remote-endpoint = <&usb3_dwc>;
26 led-controller {
27 compatible = "gpio-leds";
28 pinctrl-names = "default";
29 pinctrl-0 = <&pinctrl_gpio_leds>;
31 led-0 {
35 default-state = "on";
36 linux,default-trigger = "heartbeat";
39 led-1 {
43 default-state = "off";
47 pcie0_refclk: clock-pcie0 {
48 compatible = "fixed-clock";
49 #clock-cells = <0>;
50 clock-frequency = <100000000>;
54 compatible = "pps-gpio";
55 pinctrl-names = "default";
56 pinctrl-0 = <&pinctrl_pps>;
62 /* off-board header */
64 pinctrl-names = "default";
65 pinctrl-0 = <&pinctrl_spi2>;
66 cs-gpios = <&gpio5 13 GPIO_ACTIVE_LOW>,
71 compatible = "atmel,attpm20p", "tcg,tpm_tis-spi";
73 spi-max-frequency = <36000000>;
78 gpio-line-names =
90 clock-frequency = <400000>;
91 pinctrl-names = "default";
92 pinctrl-0 = <&pinctrl_i2c2>;
98 pinctrl-names = "default";
99 pinctrl-0 = <&pinctrl_accel>;
100 st,drdy-int-pin = <1>;
101 interrupt-parent = <&gpio4>;
107 fsl,refclk-pad-mode = <IMX8_PCIE_REFCLK_PAD_INPUT>;
108 fsl,clkreq-unsupported;
110 clock-names = "ref";
115 pinctrl-names = "default";
116 pinctrl-0 = <&pinctrl_pcie0>;
117 reset-gpio = <&gpio4 29 GPIO_ACTIVE_LOW>;
123 pinctrl-names = "default";
124 pinctrl-0 = <&pinctrl_uart1>;
128 /* off-board header */
130 pinctrl-names = "default";
131 pinctrl-0 = <&pinctrl_uart3>;
135 /* USB1 Type-C front panel */
137 pinctrl-names = "default";
138 pinctrl-0 = <&pinctrl_usb1>;
139 fsl,over-current-active-low;
149 adp-disable;
150 hnp-disable;
151 srp-disable;
153 usb-role-switch;
154 role-switch-default-mode = "peripheral";
159 remote-endpoint = <&usb_dr_connector>;
164 /* USB2 - MiniPCIe socket */
166 fsl,permanently-attached;
167 fsl,disable-port-power-control;
181 pinctrl-names = "default";
182 pinctrl-0 = <&pinctrl_hog>;