16  * code.  However, some notion of "rate set" is probably still necessary
17  * for OMAP2xxx at least.  Rate sets should be generalized so they can be
19  * has in the past expressed a preference to use rate sets for OPP changes,
48  * sys_ck_rate: the rate of the external high-frequency clock
58  * Set virt_prcm_set's rate to the mpu_speed field of the current PRCM set.
67  * Look for a rate equal or less than the target rate given a configuration set.
73 static long omap2_round_to_table_rate(struct clk_hw *hw, unsigned long rate,  in omap2_round_to_table_rate()  argument
90 		if (ptr->mpu_speed <= rate)  in omap2_round_to_table_rate()
96 /* Sets basic clocks based on the specified rate */
97 static int omap2_select_table_rate(struct clk_hw *hw, unsigned long rate,  in omap2_select_table_rate()  argument
112 		if (prcm->mpu_speed <= rate) {  in omap2_select_table_rate()
119 		printk(KERN_INFO "Could not set MPU rate to %luMHz\n",  in omap2_select_table_rate()
120 		       rate / 1000000);  in omap2_select_table_rate()
165  * omap2xxx_clkt_vps_check_bootloader_rates - determine which of the rate
166  * table sets matches the current CORE DPLL hardware rate
168  * Check the MPU rate set by bootloader.  Sets the 'curr_prcm_set'
169  * global to point to the active rate set when found; otherwise, sets
175 	unsigned long rate;  in omap2xxx_clkt_vps_check_bootloader_rates()  local
177 	rate = omap2xxx_clk_get_core_rate();  in omap2xxx_clkt_vps_check_bootloader_rates()
183 		if (prcm->dpll_speed <= rate)  in omap2xxx_clkt_vps_check_bootloader_rates()
190  * omap2xxx_clkt_vps_late_init - store a copy of the sys_ck rate
192  * Store a copy of the sys_ck rate for later use by the OMAP2xxx DVFS
193  * code.  (The sys_ck rate does not -- or rather, must not -- change
195  * sys_ck rate, but before the virt_prcm_set clock rate is