Lines Matching +full:cycle2cycle +full:- +full:samecsen
1 // SPDX-License-Identifier: GPL-2.0-or-later
9 model = "INCOstartec LILLY-A83X module (DM3730)";
10 compatible = "incostartec,omap3-lilly-a83x", "ti,omap3630", "ti,omap36xx", "ti,omap3";
22 compatible = "gpio-leds";
25 label = "lilly-a83x::led1";
27 linux,default-trigger = "default-on";
33 compatible = "ti,omap-twl4030";
34 ti,model = "lilly-a83x";
40 compatible = "regulator-fixed";
41 regulator-name = "VCC3";
42 regulator-min-microvolt = <3300000>;
43 regulator-max-microvolt = <3300000>;
44 regulator-always-on;
48 compatible = "usb-nop-xceiv";
49 vcc-supply = <®_vcc3>;
50 #phy-cells = <0>;
55 pinctrl-names = "default";
57 lan9221_pins: lan9221-pins {
58 pinctrl-single,pins = <
63 tsc2048_pins: tsc2048-pins {
64 pinctrl-single,pins = <
69 mmc1cd_pins: mmc1cd-pins {
70 pinctrl-single,pins = <
77 pinctrl-names = "default";
79 uart1_pins: uart1-pins {
80 pinctrl-single,pins = <
88 uart2_pins: uart2-pins {
89 pinctrl-single,pins = <
95 uart3_pins: uart3-pins {
96 pinctrl-single,pins = <
102 i2c1_pins: i2c1-pins {
103 pinctrl-single,pins = <
109 i2c2_pins: i2c2-pins {
110 pinctrl-single,pins = <
116 i2c3_pins: i2c3-pins {
117 pinctrl-single,pins = <
123 hsusb1_pins: hsusb1-pins {
124 pinctrl-single,pins = <
126 /* GPIO 182 controls USB-Hub reset. But USB-Phy its
128 * high (PIN_OFF_OUTPUT_HIGH) to always enable USB-Hub.
135 hsusb_otg_pins: hsusb-otg-pins {
136 pinctrl-single,pins = <
152 mmc1_pins: mmc1-pins {
153 pinctrl-single,pins = <
163 spi2_pins: spi2-pins {
164 pinctrl-single,pins = <
174 pinctrl-names = "default";
176 hsusb1_2_pins: hsusb1-2-pins {
177 pinctrl-single,pins = <
193 gpio1_pins: gpio1-pins {
194 pinctrl-single,pins = <
202 pinctrl-names = "default";
203 pinctrl-0 = <&gpio1_pins>;
207 pinctrl-names = "default";
208 pinctrl-0 = <&hsusb1_pins>;
212 clock-frequency = <2600000>;
213 pinctrl-names = "default";
214 pinctrl-0 = <&i2c1_pins>;
219 interrupt-parent = <&intc>;
222 compatible = "ti,twl4030-audio";
233 vmmc1: regulator-vmmc1 {
234 regulator-always-on;
237 vdd1: regulator-vdd1 {
238 regulator-always-on;
241 vdd2: regulator-vdd2 {
242 regulator-always-on;
247 clock-frequency = <2600000>;
248 pinctrl-names = "default";
249 pinctrl-0 = <&i2c2_pins>;
253 clock-frequency = <2600000>;
254 pinctrl-names = "default";
255 pinctrl-0 = <&i2c3_pins>;
258 gpio-controller;
259 #gpio-cells = <2>;
265 pinctrl-names = "default";
266 pinctrl-0 = <&uart1_pins>;
270 pinctrl-names = "default";
271 pinctrl-0 = <&uart2_pins>;
275 pinctrl-names = "default";
276 pinctrl-0 = <&uart3_pins>;
284 cd-gpios = <&gpio4 30 GPIO_ACTIVE_LOW>;
285 cd-inverted;
286 vmmc-supply = <&vmmc1>;
287 bus-width = <4>;
288 pinctrl-names = "default";
289 pinctrl-0 = <&mmc1_pins &mmc1cd_pins>;
290 cap-sdio-irq;
291 cap-sd-highspeed;
292 cap-mmc-highspeed;
305 pinctrl-names = "default";
306 pinctrl-0 = <&spi2_pins>;
311 interrupt-parent = <&gpio1>;
313 spi-max-frequency = <1000000>;
314 pendown-gpio = <&gpio1 8 GPIO_ACTIVE_LOW>;
315 vcc-supply = <®_vcc3>;
316 pinctrl-names = "default";
317 pinctrl-0 = <&tsc2048_pins>;
319 ti,x-min = /bits/ 16 <300>;
320 ti,x-max = /bits/ 16 <3000>;
321 ti,y-min = /bits/ 16 <600>;
322 ti,y-max = /bits/ 16 <3600>;
323 ti,x-plate-ohms = /bits/ 16 <80>;
324 ti,pressure-max = /bits/ 16 <255>;
325 ti,swap-xy;
327 wakeup-source;
336 pinctrl-names = "default";
337 pinctrl-0 = <&hsusb1_2_pins>;
338 num-ports = <2>;
339 port1-mode = "ehci-phy";
343 pinctrl-names = "default";
344 pinctrl-0 = <&hsusb_otg_pins>;
345 interface-type = <0>;
346 usb-phy = <&usb2_phy>;
348 phy-names = "usb2-phy";
362 compatible = "ti,omap2-nand";
364 interrupt-parent = <&gpmc>;
367 nand-bus-width = <16>;
368 ti,nand-ecc-opt = "bch8";
371 gpmc,mux-add-data = <0>;
372 gpmc,device-width = <2>;
373 gpmc,wait-pin = <0>;
374 gpmc,wait-monitoring-ns = <0>;
375 gpmc,burst-length = <4>;
376 gpmc,cs-on-ns = <0>;
377 gpmc,cs-rd-off-ns = <100>;
378 gpmc,cs-wr-off-ns = <100>;
379 gpmc,adv-on-ns = <0>;
380 gpmc,adv-rd-off-ns = <100>;
381 gpmc,adv-wr-off-ns = <100>;
382 gpmc,oe-on-ns = <5>;
383 gpmc,oe-off-ns = <75>;
384 gpmc,we-on-ns = <5>;
385 gpmc,we-off-ns = <75>;
386 gpmc,rd-cycle-ns = <100>;
387 gpmc,wr-cycle-ns = <100>;
388 gpmc,access-ns = <60>;
389 gpmc,page-burst-access-ns = <5>;
390 gpmc,bus-turnaround-ns = <0>;
391 gpmc,cycle2cycle-samecsen;
392 gpmc,cycle2cycle-delay-ns = <50>;
393 gpmc,wr-data-mux-bus-ns = <75>;
394 gpmc,wr-access-ns = <155>;
396 #address-cells = <1>;
397 #size-cells = <1>;
405 label = "u-boot";
410 label = "u-boot-environment";
427 bank-width = <2>;
428 gpmc,mux-add-data = <2>;
429 gpmc,cs-on-ns = <10>;
430 gpmc,cs-rd-off-ns = <60>;
431 gpmc,cs-wr-off-ns = <60>;
432 gpmc,adv-on-ns = <0>;
433 gpmc,adv-rd-off-ns = <10>;
434 gpmc,adv-wr-off-ns = <10>;
435 gpmc,oe-on-ns = <10>;
436 gpmc,oe-off-ns = <60>;
437 gpmc,we-on-ns = <10>;
438 gpmc,we-off-ns = <60>;
439 gpmc,rd-cycle-ns = <100>;
440 gpmc,wr-cycle-ns = <100>;
441 gpmc,access-ns = <50>;
442 gpmc,page-burst-access-ns = <5>;
443 gpmc,bus-turnaround-ns = <0>;
444 gpmc,cycle2cycle-delay-ns = <75>;
445 gpmc,wr-data-mux-bus-ns = <15>;
446 gpmc,wr-access-ns = <75>;
447 gpmc,cycle2cycle-samecsen;
448 gpmc,cycle2cycle-diffcsen;
449 vddvario-supply = <®_vcc3>;
450 vdd33a-supply = <®_vcc3>;
451 reg-io-width = <4>;
452 interrupt-parent = <&gpio5>;
455 pinctrl-names = "default";
456 pinctrl-0 = <&lan9221_pins>;
457 phy-mode = "mii";