Lines Matching +full:simple +full:- +full:card
1 // SPDX-License-Identifier: GPL-2.0-only
8 model = "Phytec AM335x phyBOARD-WEGA";
9 compatible = "phytec,am335x-wega", "phytec,am335x-phycore-som", "ti,am33xx";
12 compatible = "simple-audio-card";
13 simple-audio-card,name = "snd-wega";
14 simple-audio-card,format = "i2s";
15 simple-audio-card,bitclock-master = <&sound_iface_main>;
16 simple-audio-card,frame-master = <&sound_iface_main>;
17 simple-audio-card,mclk-fs = <512>;
18 simple-audio-card,widgets =
22 simple-audio-card,routing =
30 sound_iface_main: simple-audio-card,cpu {
31 sound-dai = <&mcasp0>;
34 simple-audio-card,codec {
35 sound-dai = <&tlv320aic3007>;
41 compatible = "regulator-fixed";
42 regulator-name = "vcc3v3";
43 regulator-min-microvolt = <3300000>;
44 regulator-max-microvolt = <3300000>;
45 regulator-boot-on;
51 mcasp0_pins: pinmux-mcasp0-pins {
52 pinctrl-single,pins = <
64 #sound-dai-cells = <0>;
67 AVDD-supply = <&vcc3v3>;
68 IOVDD-supply = <&vcc3v3>;
69 DRVDD-supply = <&vcc3v3>;
70 DVDD-supply = <&vdig1_reg>;
76 #sound-dai-cells = <0>;
77 pinctrl-names = "default";
78 pinctrl-0 = <&mcasp0_pins>;
79 op-mode = <0>; /* DAVINCI_MCASP_IIS_MODE */
80 tdm-slots = <2>;
81 serial-dir = <
84 tx-num-evt = <16>;
85 rx-num-evt = <16>;
92 dcan1_pins: pinmux-dcan1-pins {
93 pinctrl-single,pins = <
101 pinctrl-names = "default";
102 pinctrl-0 = <&dcan1_pins>;
108 ethernet1_pins: pinmux-ethernet1-pins {
109 pinctrl-single,pins = <
130 phy-handle = <&phy1>;
131 phy-mode = "mii";
132 ti,dual-emac-pvid = <2>;
136 phy1: ethernet-phy@1 {
142 pinctrl-names = "default";
143 pinctrl-0 = <ðernet0_pins ðernet1_pins>;
148 mmc1_pins: pinmux-mmc1-pins {
149 pinctrl-single,pins = <
162 vmmc-supply = <&vcc3v3>;
163 bus-width = <4>;
164 pinctrl-names = "default";
165 pinctrl-0 = <&mmc1_pins>;
166 cd-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
172 regulator-boot-on;
173 regulator-always-on;
178 uart0_pins: pinmux-uart0-pins {
179 pinctrl-single,pins = <
185 uart1_pins: pinmux-uart1-pins {
186 pinctrl-single,pins = <
196 pinctrl-names = "default";
197 pinctrl-0 = <&uart0_pins>;
202 pinctrl-names = "default";
203 pinctrl-0 = <&uart1_pins>;