Lines Matching +full:neg +full:- +full:edge
1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
3 * Copyright (C) Geanix ApS 2023 - All Rights Reserved
7 /dts-v1/;
11 #include "stm32mp15xx-osd32.dtsi"
12 #include "stm32mp15xxac-pinctrl.dtsi"
14 #include <dt-bindings/gpio/gpio.h>
15 #include <dt-bindings/pinctrl/stm32-pinfunc.h>
19 compatible = "oct,stm32mp157c-osd32-red", "oct,stm32mp15xx-osd32", "st,stm32mp157";
26 stdout-path = "serial0:115200n8";
29 led-controller-0 {
30 compatible = "gpio-leds";
32 led-0 {
35 linux,default-trigger = "heartbeat";
49 pinctrl-names = "default", "sleep";
50 pinctrl-0 = <ðernet0_rgmii_pins_a>;
51 pinctrl-1 = <ðernet0_rgmii_sleep_pins_a>;
52 phy-mode = "rgmii-id";
53 max-speed = <1000>;
54 phy-handle = <&phy0>;
55 st,eth-clk-sel;
59 compatible = "snps,dwmac-mdio";
60 #address-cells = <1>;
61 #size-cells = <0>;
63 phy0: ethernet-phy@3 {
70 timeout-sec = <32>;
75 pinctrl-names = "default", "sleep";
76 pinctrl-0 = <&i2c1_pins_a>;
77 pinctrl-1 = <&i2c1_sleep_pins_a>;
79 i2c-scl-rising-time-ns = <100>;
80 i2c-scl-falling-time-ns = <7>;
82 /delete-property/dmas;
83 /delete-property/dma-names;
85 hdmi-transmitter@39 {
88 reset-gpios = <&gpiog 0 GPIO_ACTIVE_LOW>;
90 interrupt-parent = <&gpiog>;
91 pinctrl-names = "default", "sleep";
92 pinctrl-0 = <<dc_pins_e>;
93 pinctrl-1 = <<dc_sleep_pins_e>;
96 #address-cells = <1>;
97 #size-cells = <0>;
102 remote-endpoint = <<dc_ep0_out>;
109 remote-endpoint = <&i2s2_endpoint>;
118 clock-names = "pclk", "i2sclk", "x8k", "x11k";
119 pinctrl-names = "default", "sleep";
120 pinctrl-0 = <&i2s2_pins_b>;
121 pinctrl-1 = <&i2s2_sleep_pins_b>;
126 remote-endpoint = <&sii9022_tx_endpoint>;
127 dai-format = "i2s";
128 mclk-fs = <256>;
138 remote-endpoint = <&sii9022_in>;
144 pinctrl-names = "default", "sleep";
145 pinctrl-0 = <&m_can1_pins_d>;
146 pinctrl-1 = <&m_can1_sleep_pins_d>;
155 pinctrl-names = "default", "opendrain", "sleep";
156 pinctrl-0 = <&sdmmc1_b4_pins_a>;
157 pinctrl-1 = <&sdmmc1_b4_od_pins_a>;
158 pinctrl-2 = <&sdmmc1_b4_sleep_pins_a>;
159 cd-gpios = <&gpioe 7 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
160 disable-wp;
161 st,neg-edge;
162 bus-width = <4>;
163 vmmc-supply = <&v3v3>;
168 pinctrl-names = "default", "opendrain", "sleep";
169 pinctrl-0 = <&sdmmc2_b4_pins_a &sdmmc2_d47_pins_d>;
170 pinctrl-1 = <&sdmmc2_b4_od_pins_a>;
171 pinctrl-2 = <&sdmmc2_b4_sleep_pins_a &sdmmc2_d47_sleep_pins_d>;
172 non-removable;
173 no-sd;
174 no-sdio;
175 st,neg-edge;
176 bus-width = <8>;
177 vmmc-supply = <&v3v3>;
178 vqmmc-supply = <&vdd>;
179 mmc-ddr-3_3v;
184 pinctrl-names = "default", "sleep", "idle";
185 pinctrl-0 = <&uart4_pins_a>;
186 pinctrl-1 = <&uart4_sleep_pins_a>;
187 pinctrl-2 = <&uart4_idle_pins_a>;
189 /delete-property/dmas;
190 /delete-property/dma-names;
203 vbus-supply = <&vbus_otg>;