Lines Matching +full:vs +full:- +full:supply
1 // SPDX-License-Identifier: GPL-2.0 OR X11
3 * Device Tree Include file for TQ-Systems TQMa7x boards with full mounted PCB.
5 * Copyright (C) 2016 TQ-Systems GmbH
6 * Author: Markus Niebel <Markus.Niebel@tq-group.com>
13 /* 512 MB - default configuration */
19 cpu-supply = <&sw1a_reg>;
24 qspi-reset-hog {
25 gpio-hog;
28 line-name = "qspi-reset";
33 pinctrl-names = "default", "gpio";
34 pinctrl-0 = <&pinctrl_i2c1>;
35 pinctrl-1 = <&pinctrl_i2c1_recovery>;
36 scl-gpios = <&gpio4 8 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
37 sda-gpios = <&gpio4 9 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
38 clock-frequency = <100000>;
42 pinctrl-names = "default";
43 pinctrl-0 = <&pinctrl_pmic1>;
49 regulator-min-microvolt = <700000>;
50 regulator-max-microvolt = <3300000>;
51 regulator-boot-on;
52 regulator-always-on;
53 regulator-ramp-delay = <6250>;
58 regulator-min-microvolt = <700000>;
59 regulator-max-microvolt = <1475000>;
60 regulator-boot-on;
61 regulator-always-on;
62 regulator-ramp-delay = <6250>;
66 regulator-min-microvolt = <1500000>;
67 regulator-max-microvolt = <1850000>;
68 regulator-boot-on;
69 regulator-always-on;
73 regulator-min-microvolt = <900000>;
74 regulator-max-microvolt = <1650000>;
75 regulator-boot-on;
76 regulator-always-on;
80 regulator-min-microvolt = <5000000>;
81 regulator-max-microvolt = <5150000>;
85 regulator-min-microvolt = <1000000>;
86 regulator-max-microvolt = <3000000>;
87 regulator-boot-on;
88 regulator-always-on;
92 regulator-boot-on;
93 regulator-always-on;
97 regulator-min-microvolt = <1800000>;
98 regulator-max-microvolt = <3300000>;
99 regulator-always-on;
103 regulator-min-microvolt = <800000>;
104 regulator-max-microvolt = <1550000>;
105 regulator-always-on;
109 regulator-min-microvolt = <2850000>;
110 regulator-max-microvolt = <3300000>;
111 regulator-always-on;
115 regulator-min-microvolt = <3300000>;
116 regulator-max-microvolt = <3300000>;
117 regulator-always-on;
121 regulator-min-microvolt = <1800000>;
122 regulator-max-microvolt = <3300000>;
123 regulator-always-on;
127 regulator-min-microvolt = <1800000>;
128 regulator-max-microvolt = <3300000>;
129 regulator-always-on;
135 lm75a: temperature-sensor@48 {
138 vs-supply = <&vgen4_reg>;
142 se97b: temperature-sensor@1e {
143 compatible = "nxp,se97b", "jedec,jc-42.4-temp";
150 read-only;
153 vcc-supply = <&vgen4_reg>;
160 vcc-supply = <&vgen4_reg>;
258 pinctrl-names = "default";
259 pinctrl-0 = <&pinctrl_qspi &pinctrl_qspi_reset>;
263 compatible = "jedec,spi-nor";
265 spi-max-frequency = <29000000>;
266 spi-rx-bus-width = <4>;
267 spi-tx-bus-width = <4>;
268 vcc-supply = <&vgen4_reg>;
271 compatible = "fixed-partitions";
272 #address-cells = <1>;
273 #size-cells = <1>;
279 pinctrl-names = "default", "state_100mhz", "state_200mhz";
280 pinctrl-0 = <&pinctrl_usdhc3>;
281 pinctrl-1 = <&pinctrl_usdhc3_100mhz>;
282 pinctrl-2 = <&pinctrl_usdhc3_200mhz>;
283 assigned-clocks = <&clks IMX7D_USDHC3_ROOT_CLK>;
284 assigned-clock-rates = <400000000>;
285 bus-width = <8>;
286 non-removable;
287 no-sd;
288 no-sdio;
289 vmmc-supply = <&vgen4_reg>;
290 vqmmc-supply = <&sw2_reg>;
295 pinctrl-names = "default";
296 pinctrl-0 = <&pinctrl_wdog1>;
300 * X1-51 (WDOG1#) signal needs carrier board handling to reset
301 * TQMa7 on X1-22 (RESET_IN#).
303 fsl,ext-reset-output;