Lines Matching +full:uart +full:- +full:grp
4 * This file is dual-licensed: you can use it either under the terms
22 * MA 02110-1301 USA
48 /dts-v1/;
50 #include <dt-bindings/gpio/gpio.h>
55 compatible = "revotics,imx6sl-warp", "fsl,imx6sl";
63 compatible = "mmc-pwrseq-simple";
64 reset-gpios = <&gpio4 5 GPIO_ACTIVE_LOW>, /* WL_REG_ON */
74 pinctrl-names = "default";
75 pinctrl-0 = <&pinctrl_uart1>;
80 pinctrl-names = "default";
81 pinctrl-0 = <&pinctrl_uart3>;
86 pinctrl-names = "default";
87 pinctrl-0 = <&pinctrl_uart5>;
88 uart-has-rtscts;
94 disable-over-current;
100 disable-over-current;
105 pinctrl-names = "default", "state_100mhz", "state_200mhz";
106 pinctrl-0 = <&pinctrl_usdhc2>;
107 pinctrl-1 = <&pinctrl_usdhc2_100mhz>;
108 pinctrl-2 = <&pinctrl_usdhc2_200mhz>;
109 bus-width = <8>;
110 non-removable;
115 pinctrl-names = "default", "state_100mhz", "state_200mhz";
116 pinctrl-0 = <&pinctrl_usdhc3>;
117 pinctrl-1 = <&pinctrl_usdhc3_100mhz>;
118 pinctrl-2 = <&pinctrl_usdhc3_200mhz>;
119 bus-width = <4>;
120 non-removable;
121 keep-power-in-suspend;
122 wakeup-source;
123 mmc-pwrseq = <&usdhc3_pwrseq>;
168 pinctrl_usdhc2_100mhz: usdhc2-100mhz-grp {
184 pinctrl_usdhc2_200mhz: usdhc2-200mhz-grp {
211 pinctrl_usdhc3_100mhz: usdhc3-100mhz-grp {
222 pinctrl_usdhc3_200mhz: usdhc3-200mhz-grp {