Lines Matching +full:non +full:- +full:dual
4 * This file is dual-licensed: you can use it either under the terms
5 * of the GPL or the X11 license, at your option. Note that this dual
43 #include "sun8i-h3-nanopi.dtsi"
47 compatible = "friendlyarm,nanopi-m1-plus", "allwinner,sun8i-h3";
55 reg_gmac_3v3: gmac-3v3 {
56 compatible = "regulator-fixed";
57 regulator-name = "gmac-3v3";
58 regulator-min-microvolt = <3300000>;
59 regulator-max-microvolt = <3300000>;
60 startup-delay-us = <100000>;
61 enable-active-high;
66 compatible = "mmc-pwrseq-simple";
67 reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */
71 compatible = "hdmi-connector";
76 remote-endpoint = <&hdmi_out_con>;
95 pinctrl-names = "default";
96 pinctrl-0 = <&emac_rgmii_pins>;
97 phy-supply = <®_gmac_3v3>;
98 phy-handle = <&ext_rgmii_phy>;
99 phy-mode = "rgmii";
105 ext_rgmii_phy: ethernet-phy@1 {
106 compatible = "ethernet-phy-ieee802.3-c22";
117 remote-endpoint = <&hdmi_con_in>;
122 pinctrl-names = "default";
123 pinctrl-0 = <&r_ir_rx_pin>;
128 vmmc-supply = <®_vcc3v3>;
129 vqmmc-supply = <®_vcc3v3>;
130 mmc-pwrseq = <&wifi_pwrseq>;
131 bus-width = <4>;
132 non-removable;
137 compatible = "brcm,bcm4329-fmac";
138 interrupt-parent = <&pio>;
140 interrupt-names = "host-wake";
145 pinctrl-names = "default";
146 pinctrl-0 = <&mmc2_8bit_pins>;
147 vmmc-supply = <®_vcc3v3>;
148 vqmmc-supply = <®_vcc3v3>;
149 bus-width = <8>;
150 non-removable;
163 pinctrl-names = "default";
164 pinctrl-0 = <&uart3_pins>, <&uart3_rts_cts_pins>;