Lines Matching +full:os +full:- +full:initiated
1 .. SPDX-License-Identifier: GPL-2.0
4 Timekeeping Virtualization for X86-Based Architectures
32 information relevant to KVM and hardware-based virtualization.
41 2.1. i8254 - PIT
42 ----------------
46 channels which can be programmed to deliver periodic or one-shot interrupts.
53 The PIT uses I/O ports 0x40 - 0x43. Access to the 16-bit counters is done
59 -------------- ----------------
61 | 1.1932 MHz|---------->| CLOCK OUT | ---------> IRQ 0
63 -------------- | +->| GATE TIMER 0 |
64 | ----------------
66 | ----------------
68 |------>| CLOCK OUT | ---------> 66.3 KHZ DRAM
70 | +->| GATE TIMER 1 |
71 | ----------------
73 | ----------------
75 |------>| CLOCK OUT | ---------> Port 61h, bit 5
77 Port 61h, bit 0 -------->| GATE TIMER 2 | \_.---- ____
78 ---------------- _| )--|LPF|---Speaker
79 / *---- \___/
80 Port 61h, bit 1 ---------------------------------/
85 This is a one-shot software timeout that counts down
89 Mode 1: Triggered One-shot.
91 line is set high, a countdown is initiated (which does not stop if the gate is
110 for (N-1)/2 counts. Only even values are latched by the counter, so odd
112 which generates sine-like tones by low-pass filtering the square wave output.
122 output remains high. When the gate is raised, a countdown is initiated
133 Bit 7-4: Command (See table below)
134 Bit 3-1: Mode (000 = Mode 0, 101 = Mode 5, 11X = undefined)
139 0000 - Latch Timer 0 count for port 0x40
144 0001 - Set Timer 0 LSB mode for port 0x40
148 0010 - Set Timer 0 MSB mode for port 0x40
152 0011 - Set Timer 0 16-bit mode for port 0x40
156 0100 - Latch Timer 1 count for port 0x41 - as described above
157 0101 - Set Timer 1 LSB mode for port 0x41 - as described above
158 0110 - Set Timer 1 MSB mode for port 0x41 - as described above
159 0111 - Set Timer 1 16-bit mode for port 0x41 - as described above
161 1000 - Latch Timer 2 count for port 0x42 - as described above
162 1001 - Set Timer 2 LSB mode for port 0x42 - as described above
163 1010 - Set Timer 2 MSB mode for port 0x42 - as described above
164 1011 - Set Timer 2 16-bit mode for port 0x42 as described above
166 1101 - General counter latch
173 1110 - Latch timer status
179 The output of ports 0x40-0x42 following this command will be:
183 Bit 5-4 = Read / Write mode
186 11 = LSB / MSB (16-bit)
187 Bit 3-1 = Mode
191 --------
212 The clock uses a 32.768kHz crystal, so bits 6-4 of register A should be
218 ------------------------------------------
231 bit 6-4 = Divider for clock
238 bit 3-0 = Rate selection for periodic interrupt
252 bit 4 = Update-ended interrupt enable
255 bit 1 = 12-hour mode (0) / 24-hour mode (1)
262 bit 3-0 = reserved
265 bit 6-0 = reserved
270 ---------
272 On Pentium and later processors, an on-board timer is available to each CPU
274 accessed through memory-mapped registers and provides interrupt service to each
279 the APIC CPU-local memory-mapped hardware. Beware that CPU errata may affect
281 these workarounds pose unique constraints for virtualization - requiring either
282 extra overhead incurred from extra reads of memory-mapped I/O or additional
288 of one-shot or periodic operation, and is based on the bus clock divided down
292 ---------
307 in any given system). The HPET is also memory-mapped, and its presence is
314 --------------------
332 The TSC is represented internally as a 64-bit MSR which can be read with the
335 was only possible to write the low 32-bits of the 64-bit counter, and the upper
336 32-bits of the counter were cleared. Now, however, on Intel processors family
338 has been lifted and all 64-bits are writable. On AMD systems, the ability to
341 The TSC is accessible from CPL-0 and conditionally, for CPL > 0 software by
357 ------------------------
359 The TSC is a CPU-local clock in most implementations. This means, on SMP
366 Several hardware limitations make the problem worse - if it is not possible to
367 write the full 64-bits of the TSC, it may be impossible to match the TSC in
375 ------------------------
383 small, may be exposed to the OS and any virtualization environment.
385 3.3. TSC and multi-socket / NUMA
386 --------------------------------
388 Multi-socket systems, especially large multi-socket systems are likely to have
397 cores. This technique, known as spread-spectrum clocking, reduces EMI at the
404 3.4. TSC and C-states
405 ---------------------
407 C-states, or idling states of the processor, especially C1E and deeper sleep
416 3.5. TSC frequency change / P-states
417 ------------------------------------
426 Whether the TSC runs at a constant rate or scales with the P-state is model
430 In addition, some vendors have known bugs where the P-state is actually
432 inactive, the P-state may be raised temporarily to service cache misses from
434 than that of non-halted processors. AMD Turion processors are known to have
437 3.6. TSC and STPCLK / T-states
438 ------------------------------
445 3.7. TSC virtualization - VMX
446 -----------------------------
454 3.8. TSC virtualization - SVM
455 -----------------------------
463 ------------------------------
467 if so, the TSCs in multi-sockets or NUMA systems may still run independently
476 X86_FEATURE_CONSTANT_TSC The TSC rate is unchanged with P-states
477 X86_FEATURE_NONSTOP_TSC The TSC does not stop in C-states
502 -----------------------
532 -----------------------------------
543 non-serialized. Forcing serialized execution is necessary for precise
555 ----------------------
563 Due to non-serialized reads, you may actually end up with a range which
564 fluctuates - from (T-1.. T+10). Thus, any time calculated from a TSC, but
566 Re-calibrating this computation may actually cause time, as computed after the
572 timespec - but which advances in much larger granularity intervals, sometimes
580 --------------
586 typically small enough to fall in the NTP-correctable window.
599 ---------------
613 --------------
622 --------------------------------
628 adequately virtualized without a full real-time operating system, which would
636 ------------------------------
641 red-pill type detection), and it may allow information to leak between guests
645 but in general isn't recommended for real-world deployment scenarios.