Lines Matching +full:battery +full:- +full:temperature
7 Power supply class used to represent battery, UPS, AC or DC power supply
8 properties to user-space.
25 typically expected feedback of battery charging/fully charged status and
60 +--------------------------------------------------------------------------+
61 | **Charge/Energy/Capacity - how to not confuse** |
62 +--------------------------------------------------------------------------+
64 | of battery, this class distinguish these terms. Don't mix them!** |
66 | - `CHARGE_*` |
68 | - `ENERGY_*` |
70 | - `CAPACITY` |
72 +--------------------------------------------------------------------------+
85 `BATTERY_STATUS_*` values, as defined in battery.h.
94 indicates the power supply (battery or charger) connected
98 represents health of the battery, values corresponds to
99 POWER_SUPPLY_HEALTH_*, defined in battery.h.
102 open circuit voltage of the battery.
106 Maximal/minimal means values of voltages when battery considered
108 between voltage and battery capacity, but some dumb
110 Battery driver also can use this attribute just to inform userspace
111 about maximal and minimal voltage thresholds of a given battery.
125 design charge values, when battery considered full/empty.
131 These attributes means "last remembered value of charge when battery
132 became full/empty". It also could mean "value of charge when battery
133 considered full/empty at given conditions (temperature, age)".
142 relative, time-based measurements.
146 (typically 20% of battery capacity).
149 Charge termination current. The charge cycle terminates when battery
151 this setting (typically 10% of battery capacity).
181 battery or coulomb counter calibration status
193 temperature of the power supply.
195 minimum battery temperature alert.
197 maximum battery temperature alert.
199 ambient temperature.
201 minimum ambient temperature alert.
203 maximum ambient temperature alert.
205 minimum operatable temperature
207 maximum operatable temperature
210 seconds left for battery to be considered empty
211 (i.e. while battery powers a load)
213 seconds left for battery to be considered full
214 (i.e. while battery is charging)
217 Battery <-> external power supply interaction
232 Devicetree battery characteristics
234 Drivers should call power_supply_get_battery_info() to obtain battery
235 characteristics from a devicetree battery node, defined in
236 Documentation/devicetree/bindings/power/supply/battery.yaml. This is
240 battery node have names corresponding to elements in enum power_supply_property,
241 for naming consistency between sysfs attributes and battery node properties.
261 I have some very specific attribute (e.g. battery color), should I add
267 some general battery specification/standard, it may be a candidate to
272 Suppose, my battery monitoring chip/firmware does not provides capacity
281 model is not subject of work for a battery driver. Such functionality
284 approximating remaining battery capacity based on its charge, current,
285 voltage and so on. But full-fledged battery model is likely not subject