Lines Matching +full:sets +full:- +full:of +full:- +full:ports

1 .. SPDX-License-Identifier: GPL-2.0
14    - Normal (routed) and Ethernet-bridged (Ethernet device emulation)
16    - ARP support (no InARP support in the kernel - there is an
17      experimental InARP user-space daemon available on:
20 2. raw HDLC - either IP (IPv4) interface or Ethernet device emulation
25 Generic HDLC is a protocol driver only - it needs a low-level driver
28 Ethernet device emulation (using HDLC or Frame-Relay PVC) is compatible
33 create a number of "hdlc" (hdlc0 etc) network devices, one for each
40 	gcc -O2 -Wall -o sethdlc sethdlc.c
42 Make sure you're using a correct version of sethdlc for your kernel.
66     - sets physical interface for a given port
67       if the card has software-selectable interfaces
69     - activate hardware loopback (for testing only)
71     - both RX clock and TX clock external
73     - both RX clock and TX clock internal
75     - RX clock external, TX clock internal
77     - RX clock external, TX clock derived from RX clock
79     - sets clock rate in bps (for "int" or "txint" clock only)
84 * hdlc - sets raw HDLC (IP-only) mode
86   nrz / nrzi / fm-mark / fm-space / manchester - sets transmission code
88   no-parity / crc16 / crc16-pr0 (CRC16 with preset zeros) / crc32-itu
90   crc16-itu (CRC16 with ITU-T polynomial) / crc16-itu-pr0 - sets parity
92 * hdlc-eth - Ethernet device emulation using HDLC. Parity and encoding
95 * cisco - sets Cisco HDLC mode (IP, IPv6 and IPX supported)
97   interval - time in seconds between keepalive packets
99   timeout - time in seconds after last received keepalive packet before
102 * ppp - sets synchronous PPP mode
104 * x25 - sets X.25 mode
106 * fr - Frame Relay mode
108   lmi ansi / ccitt / cisco / none - LMI (link management) type
110   dce - Frame Relay DCE (network) side LMI instead of default DTE (user).
114   - t391 - link integrity verification polling timer (in seconds) - user
115   - t392 - polling verification timer (in seconds) - network
116   - n391 - full status polling counter - user
117   - n392 - error threshold - both user and network
118   - n393 - monitored events count - both user and network
120 Frame-Relay only:
122 * create n | delete n - adds / deletes PVC interface with DLCI #n.
125 * create ether n | delete ether n - adds a device for Ethernet-bridged
131 Board-specific issues
132 ---------------------
136 	insmod n2 hw=io,irq,ram,ports[:io,irq,...]
152 	n2.hw=io,irq,ram,ports:...