Lines Matching +full:three +full:- +full:state

10     Addresses scanned: I2C 0x2c - 0x2f
19 -----------------
35 -----------
40 internal state that allows no clean access (Bank with ID register is not
42 parameter; this will put it into a more well-behaved state first.
44 The driver implements three temperature sensors, seven fan rotation speed
48 The driver also implements up to seven fan control outputs: pwm1-7.  Pwm1-7
53 Automatic fan control mode is possible only for fan1-fan3.
116 ----------------
118 	- This driver is only for Winbond W83792D C version device, there
120 	  calculation method to in6-in7(measured value, limits) is a little
123 	- The function of vid and vrm has not been finished, because I'm NOT
125 	- The function of chassis open detection needs more tests.
126 	- If you have ASUS server board and chip was not found: Then you will
131 -----------
134 -----------
140 --------------
145 via thermal_cruise# file. The tolerance# file serves to create T +- tolerance
147 remains below the thermal_cruise# +- tolerance# value. Once the temperature
150 with the temperature varying. Three conditions may occur:
156 limit (T-tolerance), the fan speed will be fixed at the current speed because
164 ------------
168 temperature region (sf2_point@_fan# +- tolerance#) it will cause fans to run
174 ----------
176 pwm[1-7]
177 	- this file stores PWM duty cycle or DC value (fan speed) in range:
180 pwm[1-3]_enable
181 	- this file controls mode of fan/temperature control:
187 pwm[1-7]_mode
188 	- Select PWM or DC mode
192 thermal_cruise[1-3]
193 	- Selects the desired temperature for cruise (degC)
194 tolerance[1-3]
195 	- Value in degrees of Celsius (degC) for +- T
196 sf2_point[1-4]_fan[1-3]
197 	- four temperature points for each fan for Smart Fan II
198 sf2_level[1-3]_fan[1-3]
199 	- three PWM/DC levels for each fan for Smart Fan II