Lines Matching +full:in4 +full:- +full:in5

10     Addresses scanned: I2C 0x2c - 0x2f
12     Datasheet: http://www.winbond-usa.com/products/winbond_products/pdfs/PCIC/W83791D_W83791Gb.pdf
22     - Frodo Looijaard <frodol@dds.nl>,
23     - Philip Edelbrock <phil@netroedge.com>,
24     - Mark Studebaker <mdsxyz123@yahoo.com>
28     - Shane Huang (Winbond),
29     - Rudolf Marek <r.marek@assembler.cz>
33     - Sven Anders <anders@anduras.de>
34     - Marc Hulsman <m.hulsman@tudelft.nl>
37 -----------------
62 -----------
70 parameter; this will put it into a more well-behaved state first.
91 PWM 1-3 support Thermal Cruise mode, in which the PWMs are automatically
92 regulated to keep respectively temp 1-3 at a certain target temperature.
93 See below for the description of the sysfs-interface.
105 `*_beep` files as described in `Documentation/hwmon/sysfs-interface.rst`.
110 (again following the pattern described in sysfs-interface).
114 the other. If you use the legacy bitmask method, your user-space code is
118 NOTE: All new code should be written to use the newer sysfs-interface
126 ----------
127 The sysfs-interface is documented in the 'sysfs-interface' file. Only
128 chip-specific options are documented here.
131 pwm[1-3]_enable		this file controls mode of fan/temperature control for
132 			fan 1-3. Fan/PWM 4-5 only support manual mode.
138 temp[1-3]_target	defines the target temperature for Thermal Cruise mode.
142 temp[1-3]_tolerance	temperature tolerance for Thermal Cruise mode.
150 -----------------------------------
161 in4 (+12VIN)   0x000100  0x000100
162 in5 (-12VIN)   0x000200  0x000200
163 in6 (-5VIN)    0x000400  0x000400
179 global_enable  -         0x800000  (modified via beep_enable)