Lines Matching +full:temperature +full:- +full:mode
10 Addresses scanned: I2C 0x2c - 0x2e
18 Addresses scanned: I2C 0x2c - 0x2e
31 - Frodo Looijaard <frodol@dds.nl>
32 - Philip Edelbrock <phil@netroedge.com>
35 -----------------
38 List of adapter,address pairs to force chips into ADM1022 mode with
39 second remote temperature. This does not work for original THMC50 chips.
42 -----------
44 The THMC50 implements: an internal temperature sensor, support for an
45 external diode-type temperature sensor (compatible w/ the diode sensor inside
46 many processors), and a controllable fan/analog_out DAC. For the temperature
48 register and Hysteresis register. Each value can be set and read to half-degree
50 temperature gets higher then the Overtemperature Shutdown value; it stays on
51 until the temperature falls below the Hysteresis value. All temperatures are in
52 degrees Celsius, and are guaranteed within a range of -55 to +125 degrees.
57 The THMC50 is usually used in combination with LM78-like chips, to measure
58 the temperature of the processor(s).
61 1 Hz for THMC50). It can be also put in a new mode to handle additional
62 remote temperature sensor. The driver use the mode set by BIOS by default.
64 In case the BIOS is broken and the mode is set incorrectly, you can force
65 the mode with additional remote temperature with adm1022_temp3 parameter.
69 ---------------
74 - internal
76 - remote
78 - 2nd remote only for ADM1022
81 - fan speed (0 = stop, 255 = full)
83 - always 0 (DC mode)
89 in the temp3 mode), five temperature readings and two fans.