Lines Matching +full:battery +full:- +full:temperature
174 - Christophe Gauthron
175 - Jean Delvare <jdelvare@suse.de>
179 -----------------
183 each read. Default is 0. On some boards the battery voltage is provided
184 by either the battery or the onboard power supply. Only the first reading
185 at power on will be the actual battery voltage (which the chip does
186 automatically). On other boards the battery voltage is always fed to
188 battery life but no information is given in the datasheet.
192 misconfigured by BIOS - PWM values would be inverted. This option tries
209 Provided since there are reports that system-wide acpi_enfore_resources=lax
217 -------------------
219 All the chips supported by this driver are LPC Super-I/O chips, accessed
220 through the LPC bus (ISA-like I/O ports). The IT8712F additionally has an
228 -----------
237 include an 'environment controller' with 3 temperature sensors, 3 fan
247 is stored in the Super-I/O configuration space. Due to technical limitations,
258 IT8783E/F, and late IT8712F and IT8705F also have optional 16-bit tachometer
260 not compatible with the older chips and revisions. The 16-bit tachometer mode
271 IT8728F. It only supports 3 fans, 16-bit fan mode, and the full speed mode
275 to IT8728F. It only supports 16-bit fan mode. Both chips support up to 6 fans.
277 The IT8790E, IT8792E/IT8795E and IT87952E support up to 3 fans. 16-bit fan
280 The IT8732F supports a closed-loop mode for fan control, but this is not
288 16-bit tachometer counters aren't used, fan readings can be divided by
301 2.8 volts with a resolution of 0.0109 volt. The battery voltage in8 does not
310 The driver handles this transparently so user-space doesn't have to care.
321 once-only alarms.
323 Out-of-limit readings can also result in beeping, if the chip is properly
338 -----------------
349 read-only.
353 -------------------------------------------
359 This interface implements 4 temperature vs. PWM output trip points.
362 freely chosen. The temperature of all 4 trip points can be freely chosen.
363 Additionally, trip point 1 has an hysteresis temperature attached, to
367 temperature, based on this simple rule: if the temperature value is
378 Temperature offset attributes
379 -----------------------------
381 The driver supports temp[1-3]_offset sysfs attributes to adjust the reported
382 temperature for thermal diodes or diode-connected thermal transistors.
383 If a temperature sensor is configured for thermistors, the attribute values
384 are ignored. If the thermal sensor type is Intel PECI, the temperature offset
385 must be programmed to the critical CPU temperature.