Lines Matching +full:high +full:- +full:current
10 Addresses: I2C 0x40 - 0x4f
20 Addresses: I2C 0x40 - 0x4f
30 Addresses: I2C 0x40 - 0x4f
40 Addresses: I2C 0x40 - 0x4f
50 Addresses: I2C 0x40 - 0x4f
59 -----------
61 The INA219 is a high-side current shunt and power monitor with an I2C
65 The INA220 is a high or low side current shunt and power monitor with an I2C
68 The INA226 is a current shunt and power monitor with an I2C interface.
71 INA230 and INA231 are high or low side current shunt and power monitors
75 The shunt value in micro-ohms can be set via platform data or device tree at
76 compile-time or via the shunt_resistor attribute in sysfs at run-time. Please
81 Documentation/hwmon/sysfs-interface.rst. Internally the interval is the sum of
88 ---------------------
93 curr1_input Current(mA) measurement channel
99 ------------------------------------------------
102 curr1_lcrit Critical low current
103 curr1_crit Critical high current
104 curr1_lcrit_alarm Current critical low alarm
105 curr1_crit_alarm Current critical high alarm
107 in0_crit Critical high shunt voltage
109 in0_crit_alarm Shunt voltage critical high alarm
111 in1_crit Critical high bus voltage
113 in1_crit_alarm Bus voltage critical high alarm
114 power1_crit Critical high power
115 power1_crit_alarm Power critical high alarm
122 - Configure `shunt_resistor` before configure `power1_crit`, because power
124 - Because of the underlying register implementation, only one `*crit` setting