Lines Matching +full:0 +full:x409
104 models. (default: 0)
108 match. (default: 0)
122 Report AC status in ``/proc/i8k``. (default: 0,
202 ecx Unknown, set to 0.
204 esi Unknown, set to 0.
205 edi Unknown, set to 0.
210 - setting the lower sixteen bits of ``eax`` to ``0xffff``
218 of the command code to the special ioports ``0xb2`` and ``0x84``. This interface is not
229 [WMI, Provider("Provider_DiagnosticsServices"), Dynamic, Locale("MS\\0x409"),
253 ``0x0025`` Get Fn key status Returns the Fn key pressed after SMM:
259 ``0xa069`` Get power status Returns current power status after SMM:
264 ``0x00a3`` Get fan state Returns current fan state after SMM:
267 fan state (0 - 2 or 3)
269 ``0x01a3`` Set fan state Sets the fan speed:
273 fan state (0 - 2 or 3)
275 ``0x02a3`` Get fan speed Returns the current fan speed in RPM:
281 ``0x03a3`` Get fan type Returns the fan type:
295 ``0x04a3`` Get nominal fan speed Returns the nominal RPM in each fan state:
299 in question (0 - 2 or 3)
303 ``0x05a3`` Get fan speed tolerance Returns the speed tolerance for each fan state:
307 in question (0 - 2 or 3)
311 ``0x10a3`` Get sensor temperature Returns the measured temperature:
317 ``0x11a3`` Get sensor type Returns the sensor type:
330 ``0xfea3`` Get SMM signature Returns Dell signature if interface
334 (0x44494147 or "DIAG")
336 (0x44454c4c or "DELL")
338 ``0xffa3`` Get SMM signature Same as ``0xfea3``, check both.
341 There are additional commands for enabling (``0x31a3`` or ``0x35a3``) and
342 disabling (``0x30a3`` or ``0x34a3``) automatic fan speed control.