Lines Matching +full:load +full:- +full:capacitor
1 Kernel driver bel-pfe
10 Addresses scanned: -
12 … Datasheet: https://www.belfuse.com/resources/datasheets/powersolutions/ds-bps-pfe1100-12-054xa.pdf
18 Addresses scanned: -
20 Datasheet: https://www.belfuse.com/resources/datasheets/powersolutions/ds-bps-pfe3000-series.pdf
26 -----------
33 1100 Watt AC to DC power-factor-corrected (PFC) power supply.
38 3000 Watt AC/DC power-factor-corrected (PFC) and DC-DC power supply.
46 -----------
48 This driver does not auto-detect devices. You will have to instantiate the
49 devices explicitly. Please see Documentation/i2c/instantiating-devices.rst for
52 Example: the following will load the driver for an PFE3000 at address 0x20
55 $ modprobe bel-pfe
56 $ echo pfe3000 0x20 > /sys/bus/i2c/devices/i2c-1/new_device
60 ---------------------
66 -------------
74 curr[2-3]_label "iout[1-2]"
75 curr[2-3]_input Measured output current
76 curr[2-3]_max Output current max value
77 curr[2-3]_max_alarm Output current max alarm
79 fan[1-2]_input Fan 1 and 2 speed in RPM
92 in2_input Hold up capacitor voltage
94 in[3-8]_label "vout[1-3,5-7]"
95 in[3-8]_input Measured output voltage
96 in[3-4]_alarm vout[1-2] output voltage alarm
98 power[1-2]_label "pin[1-2]"
99 power[1-2]_input Measured input power
100 power[1-2]_alarm Input power high alarm
102 power[3-4]_label "pout[1-2]"
103 power[3-4]_input Measured output power
105 temp[1-3]_input Measured temperature
106 temp[1-3]_alarm Temperature alarm
111 - curr3, fan2, vout[2-7], vcap, pin2, pout2 and temp3 attributes only