Lines Matching +full:all +full:- +full:outputs +full:- +full:2
20 Andigilog has both the PECI and pre-PECI versions of the Heceta-6, as
21 Intel calls them. Heceta-6e has high frequency PWM and Heceta-6p has
23 Heceta-6e part and aSC7621 is the Heceta-6p part. They are both in
28 have used registers below 20h for vendor-specific functions in addition
29 to those in the Intel-specified vendor range.
32 The fan speed control uses this finer value to produce a "step-less" fan
33 PWM output. These two bytes are "read-locked" to guarantee that once a
34 high or low byte is read, the other byte is locked-in until after the
37 sheet says 10-bits of resolution, although you may find the lower bits
42 data sheet. Our temperature reports and fan PWM outputs are very smooth
47 We offer GPIO features on the former VID pins. These are open-drain
48 outputs or inputs and may be used as general purpose I/O or as alarm
49 outputs that are based on temperature limits. These are in 19h and 1Ah.
69 Intel configuration. This would be useful in multi-CPU systems with
74 fan types. We can also support pulse-stretched PWM so that 3-wire fans
81 --------------------------------------------------------------------------
87 Using a 10-bit ADC, the aSC7621 measures the temperature of two remote diode
96 (PWM) outputs that are controlled by one, or a combination of three,
97 temperature zones. Both high- and low-frequency PWM ranges are supported.
104 Limit and status registers for all measured values are included to alert
112 --------
114 - Supports PECI interface and monitors internal and remote thermal diodes
115 - 2-wire, SMBus 2.0 compliant, serial interface
116 - 10-bit ADC
117 - Monitors VCCP, 2.5V, 3.3V, 5.0V, and 12V motherboard/processor supplies
118 - Programmable autonomous fan control based on temperature readings
119 - Noise filtering of temperature reading for fan speed control
120 - 0.25C digital temperature sensor resolution
121 - 3 PWM fan speed control outputs for 2-, 3- or 4-wire fans and up to 4 fan
123 - Enhanced measured temperature to Temperature Zone assignment.
124 - Provides high and low PWM frequency ranges
125 - 3 GPIO pins for custom use
126 - 24-Lead QSOP package
132 the standards defined in "sysfs-interface".
139 2 Remote 2 Temperature
143 6 PECI Processor Temperature 2
151 2 Remote 2 Temperature
155 6 PECI Processor Temperature 2
161 0 (default) Remote 2 Temperature
163 2 Remote 2 Temperature
167 6 PECI Processor Temperature 2
176 2 Remote 2 Temperature
180 6 PECI Processor Temperature 2
184 temp[1-4]_smoothing_enable / temp[1-4]_smoothing_time
197 temp[1-4]_crit
199 ALL pwm outputs will got to 100%.
201 temp[5-8]_input / temp[5-8]_enable
207 pwm[1-3]_enable
211 2 Fan on automatic control and will run at the minimum pwm
215 4-254 Ignored.
219 pwm[1-3]_auto_channels
220 Bitmap as described in sysctl-interface with the following
227 * 2
229 * 2,3
230 * 1,2,3
232 * 1,2,3,4
243 pwm[1-3]_invert
244 When set, inverts the meaning of pwm[1-3].
248 pwm[1-3]_freq
279 * 2 0.5 Sec.
304 2 2.4 Sec. (default)
316 0 1 or 2 Domains for enabled processors (default)