Lines Matching +full:over +full:- +full:volt

10     Addresses scanned: I2C 0x2c - 0x2f
20     Addresses scanned: I2C 0x2c - 0x2f
24 	http://pdfserv.maxim-ic.com/en/ds/DS1780.pdf
30     Addresses scanned: I2C 0x2c - 0x2f
37     - Frodo Looijaard <frodol@dds.nl>,
38     - Philip Edelbrock <phil@netroedge.com>,
39     - Michiel Rook <michiel@grendelproject.nl>,
40     - Grant Coady <gcoady.lk@gmail.com> with guidance
44 ---------
46 chip MSB 5-bit address. Each chip reports a unique manufacturer
50 -----------
52 microprocessor-based systems, providing measurement and limit comparison
55 be read out via an I2C-compatible serial System Management Bus, and values
56 for limit comparisons can be programmed in over the same serial bus. The
58 analog channels to ensure a fast interrupt response to any out-of-limit
67 ------------
71 each two seconds. User-space may read sysfs interface faster than the
82 The LM81 12-bit extended temperature measurement mode is not supported.
85 -----------
86 On chip temperature is reported as degrees Celsius as 9-bit signed data
88 are 8-bit signed data with resolution of one degree Celsius.
94 ---------
96 clock via a divider to an 8-bit counter. Fan speed (rpm) is calculated by:
104     - low speed alarm is disabled
105     - fan clock divider not changed
106     - auto fan clock adjuster enabled for valid fan speed reading
110     - low speed alarm is enabled
111     - fan clock divider set to max
112     - fan_min set to register value 254 which corresponds
114     - low speed alarm will be asserted if fan speed is
116     - auto fan clock adjuster disabled
120     - low speed alarm is enabled
121     - fan clock divider set to suit fan_min
122     - auto fan clock adjuster enabled: adjusts fan_min
126     - resolution of the low speed limit may be reduced
127     - alarm will be asserted
128     - auto fan clock adjuster enabled: adjusts fan_min
135 -------------
136 An analog output provides a 0 to 1.25 volt signal intended for an external
138 power up or reset. This doesn't do much on the test Intel SE440BX-2.
158 The reading is an unsigned 8-bit value, nominal voltage measurement is
166 -----------
167 The chip has five inputs to read the 5-bit VID and reports the mV value
171 -----------------
174 this pin. On an Intel SE440BX-2 the Chassis Intrusion header is
182 Alarm flags reported as 16-bit word
200 that alarm bits may be cleared on read, user-space may latch alarms and
201 provide the end-user with a method to clear alarm memory.