Lines Matching refs:ATAPI

12 transports for ATA and ATAPI devices, and SCSI<->ATA translation for ATA
119 Per-cmd ATAPI DMA capabilities filter
427     commands use :c:func:`ata_scsi_qc_complete` while ATAPI commands use
455 ATAPI NODATA or DMA
461 ATAPI PIO
463     in ATAPI NODATA or DMA, packet_task submits cdb. However, after
499 For all non-ATAPI commands, whether it fails or not, almost the same
504 However, failed ATAPI commands require more handling as REQUEST SENSE is
505 needed to acquire sense data. If an ATAPI command fails,
521 timeout and ATAPI error completion. This function will check if a qc is active
533 If EH is invoked due to a failed ATAPI qc, the qc here is completed but
611 ATA/ATAPI devices and describe how they should be handled in
639 during issuing or execution any ATA/ATAPI command.
649    is transferred. ATA/ATAPI standard states that "The device shall not
663 ATA/ATAPI device error (non-NCQ / non-CHECK CONDITION)
666 These are errors detected and reported by ATA/ATAPI devices indicating
669 errors are detected by ATA/ATAPI devices and reported using the same
676 For ATAPI commands,
688 Of errors detected as above, the following are not ATA/ATAPI device
694     corruption occurred during data transfer. Up to ATA/ATAPI-7, the
696     transfers but ATA/ATAPI-8 draft revision 1f says that the bit may be
700     Up to ATA/ATAPI-7, the standard specifies that ABRT could be set on
703     aren't allowed to use ICRC bit up to ATA/ATAPI-7, it seems to imply
706     However, ATA/ATAPI-8 draft revision 1f removes the part that ICRC
710 ATA/ATAPI device errors can be further categorized as follows.
719     but ATA/ATAPI standard specifies that the amount of transferred data
738 up to ATA/ATAPI-7 no definition of "na" can be found. However,
739 ATA/ATAPI-8 draft revision 1f describes "N/A" as follows.
749 ATAPI device CHECK CONDITION
752 ATAPI device CHECK CONDITION error is indicated by set CHK bit (ERR bit)
776 `ATA/ATAPI device error (non-NCQ / non-CHECK CONDITION) <#excatDevErr>`__
795    `ATA/ATAPI device error (non-NCQ / non-CHECK CONDITION) <#excatDevErr>`__.
883 -  When it's known that HBA is in ready state but ATA/ATAPI device is in
895 OTOH, ATA/ATAPI standard describes in detail ways to reset ATA/ATAPI
912     Although ATA/ATAPI standard doesn't describe exactly, EDD implies
923 ATAPI DEVICE RESET command
948 ATA/ATAPI standard specifies that some parameters must be maintained
954 Also, ATA/ATAPI standard requires that IDENTIFY DEVICE / IDENTIFY PACKET