Lines Matching +full:v +full:- +full:dmic +full:- +full:supply
1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/soc/tegra/nvidia,tegra20-pmc.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Thierry Reding <thierry.reding@gmail.com>
11 - Jonathan Hunter <jonathanh@nvidia.com>
16 - nvidia,tegra20-pmc
17 - nvidia,tegra30-pmc
18 - nvidia,tegra114-pmc
19 - nvidia,tegra124-pmc
20 - nvidia,tegra210-pmc
25 clock-names:
28 - const: pclk
30 - const: clk32k_in
35 '#clock-cells':
43 include/dt-bindings/soc/tegra-pmc.h for the list of Tegra PMC clock IDs.
45 '#interrupt-cells':
50 interrupt-controller: true
52 nvidia,invert-interrupt:
60 nvidia,core-power-req-active-high:
62 description: core power request active-high
64 nvidia,sys-clock-req-active-high:
66 description: system clock request active-high
68 nvidia,combined-power-req:
72 nvidia,cpu-pwr-good-en:
76 nvidia,suspend-mode:
80 - description: LP0, CPU + Core voltage off and DRAM in self-refresh
82 - description: LP1, CPU voltage off and DRAM in self-refresh
84 - description: LP2, CPU voltage off
87 nvidia,cpu-pwr-good-time:
91 nvidia,cpu-pwr-off-time:
95 nvidia,core-pwr-good-time:
96 $ref: /schemas/types.yaml#/definitions/uint32-array
99 - description: oscillator stable time
100 - description: power stable time
102 nvidia,core-pwr-off-time:
106 nvidia,lp0-vec:
107 $ref: /schemas/types.yaml#/definitions/uint32-array
111 The AVP (Audio-Video Processor) is an ARM7 processor and always being
117 - description: starting address of LP0 vector
118 - description: length of LP0 vector
120 core-supply:
124 core-domain:
131 operating-points-v2:
132 description: Should contain level, voltages and opp-supported-hw
133 property. The supported-hw is a bitfield indicating SoC speedo or
136 "#power-domain-cells":
140 - operating-points-v2
141 - "#power-domain-cells"
143 i2c-thermtrip:
145 description: On Tegra30, Tegra114 and Tegra124 if i2c-thermtrip subnode
146 exists, hardware-triggered thermal reset will be enabled.
149 nvidia,i2c-controller-id:
155 nvidia,bus-addr:
159 nvidia,reg-addr:
163 nvidia,reg-data:
165 description: power-off command to write to PMU
167 nvidia,pinmux-id:
169 description: Pinmux used by the hardware when issuing power-off command.
174 - nvidia,i2c-controller-id
175 - nvidia,bus-addr
176 - nvidia,reg-addr
177 - nvidia,reg-data
184 the powergates on the Tegra SoC. Each powergate node represents a power-
185 domain on the Tegra SoC that can be power-gated by the Tegra PMC.
187 Hardware blocks belonging to a power domain should contain "power-domains"
195 for each power-gate block inside Tegra.
198 --------------------------------------------------------------
223 "^[a-z0-9]+$":
235 power-domains:
238 '#power-domain-cells':
243 - clocks
244 - resets
245 - '#power-domain-cells'
257 depending on the pad in question. 3.3V and 1.8V signaling voltages are
265 Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
273 hsic, hv, lvds, mipi-bias, nand, pex-bias, pex-clk1, pex-clk2,
274 pex-cntrl, sdmmc1, sdmmc3, sdmmc4, sys_ddc, uart, usb0, usb1, usb2,
279 audio, audio-hv, cam, csia, csib, csic, csid, csie, csif, dbg,
280 debug-nonao, dmic, dp, dsi, dsib, dsic, dsid, emmc, emmc2, gpio,
281 hdmi, hsic, lvds, mipi-bias, pex-bias, pex-clk1, pex-clk2, pex-cntrl,
282 sdmmc1, sdmmc3, spi, spi-hv, uart, usb0, usb1, usb2, usb3, usb-bias
286 $ref: /schemas/types.yaml#/definitions/string-array
289 low-power-enable:
293 low-power-disable:
297 power-source:
304 include/dt-bindings/pinctrl/pinctrl-tegra-io-pad.h
308 switching. All of the listed Tegra210 pads except pex-cntrl support
312 audio, audio-hv, cam, dbg, dmic, gpio, pex-cntrl, sdmmc1, sdmmc3,
313 spi, spi-hv, uart
316 - pins
319 - compatible
320 - reg
321 - clock-names
322 - clocks
323 - '#clock-cells'
326 - if:
330 const: nvidia,tegra124-pmc
340 dsic, dsid, hdmi, hsic, hv, lvds, mipi-bias, nand,
341 pex-bias, pex-clk1, pex-clk2, pex-cntrl, sdmmc1,
345 - if:
349 const: nvidia,tegra210-pmc
358 enum: [ audio, audio-hv, cam, csia, csib, csic, csid, csie,
359 csif, dbg, debug-nonao, dmic, dp, dsi, dsib, dsic,
360 dsid, emmc, emmc2, gpio, hdmi, hsic, lvds, mipi-bias,
361 pex-bias, pex-clk1, pex-clk2, pex-cntrl, sdmmc1,
362 sdmmc3, spi, spi-hv, uart, usb0, usb1, usb2, usb3,
363 usb-bias ]
368 nvidia,suspend-mode: ["nvidia,core-pwr-off-time", "nvidia,cpu-pwr-off-time"]
369 nvidia,core-pwr-off-time: ["nvidia,core-pwr-good-time"]
370 nvidia,cpu-pwr-off-time: ["nvidia,cpu-pwr-good-time"]
373 - |
374 #include <dt-bindings/clock/tegra210-car.h>
375 #include <dt-bindings/pinctrl/pinctrl-tegra-io-pad.h>
376 #include <dt-bindings/soc/tegra-pmc.h>
379 compatible = "nvidia,tegra210-pmc";
381 core-supply = <®ulator>;
383 clock-names = "pclk", "clk32k_in";
384 #clock-cells = <1>;
386 nvidia,invert-interrupt;
387 nvidia,suspend-mode = <0>;
388 nvidia,cpu-pwr-good-time = <0>;
389 nvidia,cpu-pwr-off-time = <0>;
390 nvidia,core-pwr-good-time = <4587 3876>;
391 nvidia,core-pwr-off-time = <39065>;
392 nvidia,core-power-req-active-high;
393 nvidia,sys-clock-req-active-high;
395 pd_core: core-domain {
396 operating-points-v2 = <&core_opp_table>;
397 #power-domain-cells = <0>;
405 power-domains = <&pd_core>;
406 #power-domain-cells = <0>;
412 power-domains = <&pd_core>;
413 #power-domain-cells = <0>;