Lines Matching +full:sub +full:- +full:bus
10 reset consumer (the module being reset, or a module managing when a sub-
15 specifier - a list of DT cells that represents the reset signal within the
25 where it makes most sense to control it; this may be a bus node if all
26 children of the bus are affected by the reset signal, or an individual HW
35 #reset-cells: Number of cells in a reset specifier; Typically 0 for nodes
41 rst: reset-controller {
42 #reset-cells = <1>;
51 #reset-cells, then only the phandle portion of the pair will
55 reset-names: List of reset signal name strings sorted in the same order as
56 the resets property. Consumers drivers will use reset-names to
63 reset-names = "reset";
68 bus {
70 reset-names = "i2s1", "i2s2", "dma", "mixer";
73 This represents a bus that controls the reset signal of each of four sub-
74 ordinate devices. Consider for example a bus that fails to operate unless no