Lines Matching +full:ldo6 +full:- +full:8
1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/regulator/rohm,bd71837-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Matti Vaittinen <mazziesaccount@gmail.com>
15 Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml
21 regulator-boot-on at least for BUCK6 and BUCK7 so that those are not
22 disabled by driver at startup. LDO5 and LDO6 are supplied by those and
23 if they are disabled at startup the voltage monitoring for LDO5/LDO6 will
28 # LDO1, LDO2, LDO3, LDO4, LDO5, LDO6, LDO7
31 "^LDO[1-7]$":
38 regulator-name:
39 pattern: "^ldo[1-7]$"
45 "^BUCK[1-8]$":
52 regulator-name:
53 pattern: "^buck[1-8]$"
57 rohm,dvs-run-voltage:
65 rohm,dvs-idle-voltage:
73 rohm,dvs-suspend-voltage:
84 # buck | dvs-run-voltage | dvs-idle-voltage | dvs-suspend-voltage
85 # ----------------------------------------------------------------
87 # ----------------------------------------------------------------
89 # ----------------------------------------------------------------
91 # ----------------------------------------------------------------
93 # ----------------------------------------------------------------
99 # PMIC HW state machine) - then you should set this property.
102 rohm,no-regulator-enable-control:
110 # connected to feedback-pin (over suitable resistors) is getting popular
118 # |---------------|
119 # | buck 8 |-------+----->Vout
121 # |---------------| |
124 # +-------+--R2----+
128 # V FB-pull-up
132 # Vout_o = Vo - (Vpu - Vo)*R2/R1
138 # Vpu is the pull-up voltage V FB-pull-up in the picture
141 rohm,fb-pull-up-microvolt:
143 Feedback-pin has pull-up connection to adjust voltage range. This is
144 the used pull-up voltage before R1.
146 rohm,feedback-pull-up-r1-ohms:
148 Feedback-pin has pull-up connection to adjust voltage range. This is
151 rohm,feedback-pull-up-r2-ohms:
153 Feedback-pin has pull-up connection to adjust voltage range. This is
157 - regulator-name