Lines Matching +full:software +full:- +full:initiated

1 # SPDX-License-Identifier: GPL-2.0
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10   - Liam Girdwood <lgirdwood@gmail.com>
11   - Mark Brown <broonie@kernel.org>
14   regulator-name:
18   regulator-min-microvolt:
21   regulator-max-microvolt:
24   regulator-microvolt-offset:
28   regulator-min-microamp:
31   regulator-max-microamp:
34   regulator-input-current-limit-microamp:
37   regulator-always-on:
41   regulator-boot-on:
47       software cannot read the state of the regulator.
50   regulator-allow-bypass:
54   regulator-allow-set-load:
58   regulator-ramp-delay:
60       disabling ramp rate, it should be explicitly initialised to zero (regulator-ramp-delay
64   regulator-enable-ramp-delay:
73   regulator-settling-time-us:
78   regulator-settling-time-up-us:
84   regulator-settling-time-down-us:
90   regulator-soft-start:
94   regulator-initial-mode:
100   regulator-allowed-modes:
101     description: list of operating modes that software is allowed to configure
102       for the regulator at run-time.  Elements may be specified in any order.
106     $ref: /schemas/types.yaml#/definitions/uint32-array
108   regulator-system-load:
113   regulator-pull-down:
117   system-critical-regulator:
122   regulator-over-current-protection:
126   regulator-oc-protection-microamp:
132   regulator-oc-error-microamp:
138   regulator-oc-warn-microamp:
141       damaged. Recovery actions should be initiated. Zero can be passed to
145   regulator-ov-protection-microvolt:
152   regulator-ov-error-microvolt:
159   regulator-ov-warn-microvolt:
162       damaged. Recovery actions should be initiated. Zero can be passed to
167   regulator-uv-protection-microvolt:
174   regulator-uv-error-microvolt:
181   regulator-uv-warn-microvolt:
184       it gets damaged. Recovery actions should be initiated. Zero can be passed
189   regulator-uv-less-critical-window-ms:
191       critical under-voltage event during which the system can continue to
194       under-voltage event is needed, allowing for certain non-urgent actions to
197   regulator-temp-protection-kelvin:
203   regulator-temp-error-kelvin:
209   regulator-temp-warn-kelvin:
212       gets damaged. Recovery actions should be initiated. Zero can be passed to
216   regulator-active-discharge:
225   regulator-coupled-with:
227       is 2-way - all coupled regulators should be linked with each other.
229     $ref: /schemas/types.yaml#/definitions/phandle-array
233   regulator-coupled-max-spread:
236       couple specified by the regulator-coupled-with property.
237     $ref: /schemas/types.yaml#/definitions/uint32-array
239   regulator-max-step-microvolt:
244   ".*-supply$":
247   "^regulator-state-(standby|mem|disk)$":
250       sub-nodes for regulator state in Standby, Suspend-to-RAM, and
251       Suspend-to-DISK modes. Equivalent with standby, mem, and disk Linux
255       regulator-on-in-suspend:
259       regulator-off-in-suspend:
263       regulator-suspend-min-microvolt:
266       regulator-suspend-max-microvolt:
269       regulator-suspend-microvolt:
275       regulator-changeable-in-suspend:
280       regulator-mode:
292   - |
294       regulator-min-microvolt = <1000000>;
295       regulator-max-microvolt = <2500000>;
296       regulator-always-on;
297       vin-supply = <&vin>;
299       regulator-state-mem {
300         regulator-on-in-suspend;