Lines Matching +full:gpio3 +full:- +full:mode

4 - compatible: "stericsson,db8500-pinctrl", "stericsson,db8540-pinctrl",
5               "stericsson,stn8815-pinctrl"
6 - nomadik-gpio-chips: array of phandles to the corresponding GPIO chips
8 - prcm: phandle to the PRCMU managing the back end of this pin controller
10 Please refer to pinctrl-bindings.txt in this directory for details of the
23 (see pinctrl-bindings.txt):
26 - function: A string containing the name of the function to mux to the
28 - groups : An array of strings. Each string contains the name of a pin
30   set-up.
33 - pins: A string array describing the pins affected by the configuration
35 - ste,config: Handle of pin configuration node
38 - ste,input : <0/1/2>
43 - ste,output: <0/1/2>
48 - ste,sleep: <0/1>
49 	0: sleep mode disable,
50 	1: sleep mode enable.
52 - ste,sleep-input: <0/1/2/3>
58 - ste,sleep-output: <0/1/2>
63 - ste,sleep-gpio: <0/1>
64 	0: disable sleep gpio mode,
65 	1: enable sleep gpio mode.
67 - ste,sleep-wakeup: <0/1>
68 	0: wake-up detection enabled,
69 	1: wake-up detection disabled.
71 - ste,sleep-pull-disable: <0/1>
72 	0: GPIO pull-up or pull-down resistor is enabled, when pin is an input,
73 	1: GPIO pull-up and pull-down resistor are disabled.
78 		compatible = "stericsson,db8500-pinctrl";
79 		nomadik-gpio-chips = <&gpio0>, <&gpio1>, <&gpio2>, <&gpio3>;
82 		pinctrl-names = "default";
86 			ste,sleep-input = <3>;
87 			ste,sleep-wakeup = <1>;
88 			ste,sleep-pull-disable = <0>;
93 			ste,sleep-output = <1>;
94 			ste,sleep-wakeup = <1>;
95 			ste,sleep-pull-disable = <0>;
100 			ste,sleep-output = <2>;
101 			ste,sleep-wakeup = <1>;
102 			ste,sleep-pull-disable = <0>;
119 					pins = "GPIO1", "GPIO3";
133 					pins = "GPIO3";
145 		pinctrl-names = "default","sleep";
146 		pinctrl-0 = <&uart0_default_mux>, <&uart0_default_mode>;
147 		pinctrl-1 = <&uart0_sleep_mode>;