Lines Matching +full:input +full:- +full:schmitt

16 of them, so we can not make every Spreadtrum-special configuration
35 - input-enable
36 - input-disable
37 - output-high
38 - output-low
39 - bias-pull-up
40 - bias-pull-down
46 and set the pin sleep related configuration as "input-enable", which
48 input enable automatically.
54 "sprd,sleep-mode" property to set pin sleep mode.
62 - compatible: "sprd,<soc>-pinctrl"
63   Please refer to each sprd,<soc>-pinctrl.txt binding doc for supported SoCs.
64 - reg: The register address of pin controller device.
65 - pins : An array of pin names.
68 - function: Specified the function name.
69 - drive-strength: Drive strength in mA.
70 - input-schmitt-disable: Enable schmitt-trigger mode.
71 - input-schmitt-enable: Disable schmitt-trigger mode.
72 - bias-disable: Disable pin bias.
73 - bias-pull-down: Pull down on pin.
74 - bias-pull-up: Pull up on pin.
75 - input-enable: Enable pin input.
76 - input-disable: Enable pin output.
77 - output-high: Set the pin as an output level high.
78 - output-low: Set the pin as an output level low.
79 - sleep-hardware-state: Indicate these configs in this state are sleep related.
80 - sprd,control: Control values referring to databook for global control pins.
81 - sprd,sleep-mode: Sleep mode selection.
83 Please refer to each sprd,<soc>-pinctrl.txt binding doc for supported values.