Lines Matching +full:driving +full:- +full:level

8 pad driving level, system control select and so on ("domain pad
9 driving level": One pin can output 3.0v or 1.8v, depending on the
10 related domain pad driving selection, if the related domain pad
16 of them, so we can not make every Spreadtrum-special configuration
35 - input-enable
36 - input-disable
37 - output-high
38 - output-low
39 - bias-pull-up
40 - bias-pull-down
46 and set the pin sleep related configuration as "input-enable", which
54 "sprd,sleep-mode" property to set pin sleep mode.
62 - compatible: "sprd,<soc>-pinctrl"
63   Please refer to each sprd,<soc>-pinctrl.txt binding doc for supported SoCs.
64 - reg: The register address of pin controller device.
65 - pins : An array of pin names.
68 - function: Specified the function name.
69 - drive-strength: Drive strength in mA.
70 - input-schmitt-disable: Enable schmitt-trigger mode.
71 - input-schmitt-enable: Disable schmitt-trigger mode.
72 - bias-disable: Disable pin bias.
73 - bias-pull-down: Pull down on pin.
74 - bias-pull-up: Pull up on pin.
75 - input-enable: Enable pin input.
76 - input-disable: Enable pin output.
77 - output-high: Set the pin as an output level high.
78 - output-low: Set the pin as an output level low.
79 - sleep-hardware-state: Indicate these configs in this state are sleep related.
80 - sprd,control: Control values referring to databook for global control pins.
81 - sprd,sleep-mode: Sleep mode selection.
83 Please refer to each sprd,<soc>-pinctrl.txt binding doc for supported values.