Lines Matching +full:input +full:- +full:disable

1 # SPDX-License-Identifier: GPL-2.0-only
3 ---
4 $id: http://devicetree.org/schemas/pinctrl/pincfg-node.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10   - Linus Walleij <linus.walleij@linaro.org>
21   bias-disable:
23     description: disable any pin bias
25   bias-high-impedance:
27     description: high impedance mode ("third-state", "floating")
29   bias-bus-hold:
33   bias-pull-up:
35       - type: boolean
36       - $ref: /schemas/types.yaml#/definitions/uint32
40   bias-pull-down:
42       - type: boolean
43       - $ref: /schemas/types.yaml#/definitions/uint32
47   bias-pull-pin-default:
49       - type: boolean
50       - $ref: /schemas/types.yaml#/definitions/uint32
51     description: use pin-default pull state. Takes as optional argument on
54   drive-push-pull:
56       - type: boolean
57       - $ref: /schemas/types.yaml#/definitions/uint32
62   drive-open-drain:
64       - type: boolean
65       - $ref: /schemas/types.yaml#/definitions/uint32
70   drive-open-source:
74   drive-strength:
78   drive-strength-microamp:
81   input-enable:
83     description: enable input on pin (no effect on output, such as
84       enabling an input buffer)
86   input-disable:
88     description: disable input on pin (no effect on output, such as
89       disabling an input buffer)
91   input-schmitt-enable:
93     description: enable schmitt-trigger mode
95   input-schmitt-disable:
97     description: disable schmitt-trigger mode
99   input-schmitt-microvolt:
100     description: threshold strength for schmitt-trigger
102   input-debounce:
103     $ref: /schemas/types.yaml#/definitions/uint32-array
104     description: Takes the debounce time in usec as argument or 0 to disable
107   power-source:
111   low-power-enable:
115   low-power-disable:
117     description: disable low power mode
119   output-disable:
121     description: disable output on a pin (such as disable an output buffer)
123   output-enable:
128   output-impedance-ohms:
131   output-low:
135   output-high:
139   sleep-hardware-state:
144   slew-rate:
148   skew-delay:
151       this affects the expected clock skew on input pins
153       pin. Typically indicates how many double-inverters are