Lines Matching +full:wait +full:- +full:pin
4 - compatible: "lantiq,<chip>-pinctrl", where <chip> is:
10 - reg: Should contain the physical address and length of the gpio/pinmux
13 Please refer to pinctrl-bindings.txt in this directory for details of the
15 phrase "pin configuration node".
17 Lantiq's pin configuration nodes act as a container for an arbitrary number of
19 pin, a group, or a list of pins or groups. This configuration can include the
20 mux function to select on those group(s), and two pin configuration parameters:
21 pull-up and open-drain
27 other words, a subnode that lists a mux function but no pin configuration
28 parameters implies no information about any pin configuration parameters.
29 Similarly, a pin subnode that describes a pullup parameter implies no
36 Required subnode-properties:
37 - lantiq,groups : An array of strings. Each string contains the name of a group.
39 - lantiq,function: A string containing the name of the function to mux to the
56 ebu wait, nand ale, nand cs1, nand cle, spi_di, spi_do, spi_clk, spi_cs1,
67 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd,
79 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd,
104 Definition of pin configurations:
106 Required subnode-properties:
107 - lantiq,pins : An array of strings. Each string contains the name of a pin.
110 Optional subnode-properties:
111 - lantiq,pull: Integer, representing the pull-down/up to apply to the pin.
113 - lantiq,open-drain: Boolean, enables open-drain on the defined pin.
115 Valid values for AMAZON pin names:
116 Pinconf pins can be referenced via the names io0-io31.
118 Valid values for DANUBE pin names:
119 Pinconf pins can be referenced via the names io0-io31.
121 Valid values for xRX100 pin names:
122 Pinconf pins can be referenced via the names io0-io55.
124 Valid values for xRX200 pin names:
125 Pinconf pins can be referenced via the names io0-io49.
127 Valid values for xRX300 pin names:
128 Pinconf pins can be referenced via the names io0-io1,io3-io6,io8-io11,
129 io13-io19,io23-io27,io34-io36,
130 io42-io43,io48-io61.
134 compatible = "lantiq,danube-pinctrl";
135 pinctrl-names = "default";
136 pinctrl-0 = <&state_default>;
138 #gpio-cells = <2>;
139 gpio-controller;
153 lantiq,open-drain;