Lines Matching +full:level +full:- +full:triggered

7 - compatible: "brcm,bcm2835-gpio"
8 - compatible: should be one of:
9   "brcm,bcm2835-gpio" - BCM2835 compatible pinctrl
10   "brcm,bcm7211-gpio" - BCM7211 compatible pinctrl
11   "brcm,bcm2711-gpio" - BCM2711 compatible pinctrl
12   "brcm,bcm7211-gpio" - BCM7211 compatible pinctrl
13 - reg: Should contain the physical address of the GPIO module's registers.
14 - gpio-controller: Marks the device node as a GPIO controller.
15 - #gpio-cells : Should be two. The first cell is the pin number and the
17   - bit 0 specifies polarity (0 for normal, 1 for inverted)
18 - interrupts : The interrupt outputs from the controller. One interrupt per
20   additional set of per-bank interrupt line and an "all banks" wake-up
22 - interrupt-controller: Marks the device node as an interrupt controller.
23 - #interrupt-cells : Should be 2.
26     bits[3:0] trigger type and level flags:
27       1 = low-to-high edge triggered.
28       2 = high-to-low edge triggered.
29       4 = active high level-sensitive.
30       8 = active low level-sensitive.
35 Please refer to pinctrl-bindings.txt in this directory for details of the
40 more of the mux function to select on those pin(s), and pull-up/down
47 For details on each properties, you can refer to ./pinctrl-bindings.txt.
49 Required sub-node properties:
50   - pins
51   - function
53 Optional sub-node properties:
54   - bias-disable
55   - bias-pull-up
56   - bias-pull-down
57   - output-high
58   - output-low
64 Required subnode-properties:
65 - brcm,pins: An array of cells. Each cell contains the ID of a pin. Valid IDs
68 Optional subnode-properties:
69 - brcm,function: Integer, containing the function to mux to the pin(s):
78 - brcm,pull: Integer, representing the pull-down/up to apply to the pin(s):
90 		compatible = "brcm,bcm2835-gpio";
94 		gpio-controller;
95 		#gpio-cells = <2>;
97 		interrupt-controller;
98 		#interrupt-cells = <2>;