Lines Matching +full:fiber +full:- +full:mode

1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10   - Christian Marangi <ansuelsmth@gmail.com>
11   - Robert Marko <robert.marko@sartura.hr>
15   IEEE 802.3 clause 22 compliant 10BASE-Te, 100BASE-TX and
16   1000BASE-T PHY-s.
19   MAC, while second one is SGMII for connection to MAC or fiber.
21   Both models have a combo port that supports 1000BASE-X and
22   100BASE-FX fiber.
25   output only pins that natively drive LED-s for up to 2 attached
32 $ref: ethernet-phy-package.yaml#
37       - qcom,qca8072-package
38       - qcom,qca8075-package
40   qcom,package-mode:
42       PHY package can be configured in 3 mode following this table:
44                     First Serdes mode       Second Serdes mode
46                     ports 0-4
47       Option 2      PSGMII for copper       1000BASE-X / 100BASE-FX
48                     ports 0-4
50                     ports 0-3               copper port 4
52       PSGMII mode (option 1 or 2) is configured dynamically based on
56       - qsgmii
57       - psgmii
60   qcom,tx-drive-strength-milliwatt:
69   ^ethernet-phy@[a-f0-9]+$:
70     $ref: ethernet-phy.yaml#
73       qcom,dac-full-amplitude:
80           With this enabled and qcom,dac-full-bias-current
81           and qcom,dac-disable-bias-current-tweak disabled,
85       qcom,dac-full-bias-current:
93           qcom,dac-disable-bias-current-tweak disabled.
96       qcom,dac-disable-bias-current-tweak:
105           - With both FULL amplitude and FULL bias current: bias current
107           - With only DSP amplitude: bias current is set to half and
109           - With DSP bias current (included both DSP amplitude and
114       gpio-controller: true
116       '#gpio-cells':
121         - gpio-controller
129   - compatible
134   - |
135     #include <dt-bindings/leds/common.h>
138         #address-cells = <1>;
139         #size-cells = <0>;
141         ethernet-phy-package@0 {
142             #address-cells = <1>;
143             #size-cells = <0>;
144             compatible = "qcom,qca8075-package";
147             qcom,package-mode = "qsgmii";
149             ethernet-phy@0 {
153                     #address-cells = <1>;
154                     #size-cells = <0>;
160                         default-state = "keep";
165             ethernet-phy@1 {
169             ethernet-phy@2 {
172                 gpio-controller;
173                 #gpio-cells = <2>;
176             ethernet-phy@3 {
180             ethernet-phy@4 {