Lines Matching +full:phy +full:- +full:select
1 Micrel PHY properties.
7 - micrel,led-mode : LED mode value to set for PHYs with configurable LEDs.
21 See the respective PHY datasheet for the mode values.
23 - micrel,rmii-reference-clock-select-25-mhz: RMII Reference Clock Select
26 Setting the RMII Reference Clock Select bit enables 25 MHz rather
29 Note that this option in only needed for certain PHY revisions with a
30 non-standard, inverted function of this configuration bit.
31 Specifically, a clock reference ("rmii-ref" below) is always needed to
32 actually select a mode.
34 - clocks, clock-names: contains clocks according to the common clock bindings.
37 - KSZ8021, KSZ8031, KSZ8081, KSZ8091: "rmii-ref": The RMII reference
40 - micrel,fiber-mode: If present the PHY is configured to operate in fiber mode
43 by the FXEN boot strapping pin. It can't be determined from the PHY
44 registers whether the PHY is in fiber mode, so this boolean device tree
47 In fiber mode, auto-negotiation is disabled and the PHY can only work in
48 100base-fx (full and half duplex) modes.
50 - coma-mode-gpios: If present the given gpio will be deasserted when the
51 PHY is probed.
53 Some PHYs have a COMA mode input pin which puts the PHY into
54 isolate and power-down mode. On some boards this input is connected