Lines Matching +full:mt7621 +full:- +full:pinctrl
13 - compatible: Must be
14 "mediatek,mt7663u-bluetooth": for MT7663U device
15 "mediatek,mt7668u-bluetooth": for MT7668U device
16 - vcc-supply: Main voltage regulator
21 - pinctrl-names: Should be "default", "runtime"
22 - pinctrl-0: Should contain UART RXD low when the device is powered up to
24 - pinctrl-1: Should contain UART mode pin ctrl
28 a legacy MediaTek SoC, MT7621. Please use the below properties.
30 - boot-gpios: GPIO same to the pin as UART RXD and used to keep LOW when
32 - pinctrl-names: Should be "default"
33 - pinctrl-0: Should contain UART mode pin ctrl
37 - reset-gpios: GPIO used to reset the device whose initial state keeps low,
38 if the GPIO is missing, then board-level design should be
40 - clocks: Should be the clock specifiers corresponding to the entry in
41 clock-names property. If the clock is missing, then board-level
43 - clock-names: Should contain "osc" entry for the external oscillator.
44 - current-speed: Current baud rate of the device whose defaults to 921600
48 uart1_pins_boot: uart1-default {
49 pins-dat {
51 output-low;
55 uart1_pins_runtime: uart1-runtime {
56 pins-dat {
63 compatible = "mediatek,mt7623-uart",
64 "mediatek,mt6577-uart";
69 clock-names = "baud", "bus";
72 compatible = "mediatek,mt7663u-bluetooth";
73 vcc-supply = <®_5v>;
74 reset-gpios = <&pio 24 GPIO_ACTIVE_LOW>;
75 pinctrl-names = "default", "runtime";
76 pinctrl-0 = <&uart1_pins_boot>;
77 pinctrl-1 = <&uart1_pins_runtime>;
78 current-speed = <921600>;