Lines Matching +full:sub +full:- +full:bus

8 - compatible : "gpio-control-nand"
9 - reg : should specify localbus chip select and size used for the chip.  The
10   resource describes the data bus connected to the NAND flash and all accesses
12 - #address-cells, #size-cells : Must be present if the device has sub-nodes
14 - gpios : Specifies the GPIO pins to control the NAND device.  The order of
18 - bank-width : Width (in bytes) of the device.  If not present, the width
20 - chip-delay : chip dependent delay for transferring data from array to
22 - gpio-control-nand,io-sync-reg : A 64-bit physical address for a read
23   location used to guard against bus reordering with regards to accesses to
24   the GPIO's and the NAND flash data bus.  If present, then after changing
28 The device tree may optionally contain sub-nodes describing partitions of the
33 gpio-nand@1,0 {
34 	compatible = "gpio-control-nand";
36 	#address-cells = <1>;
37 	#size-cells = <1>;