Lines Matching +full:range +full:- +full:gpios

4 - compatible: "ifm,o2d-csi"
5 - reg: specifies sensor chip select number and associated address range
6 - interrupts: external interrupt line number and interrupt sense mode
8 - gpios: three gpio-specifiers for "capture", "reset" and "master enable"
9   GPIOs (strictly in this order).
10 - ifm,csi-clk-handle: the phandle to a node in the DT describing the sensor
12 - ifm,csi-addr-bus-width: address bus width (valid values are 16, 24, 25)
13 - ifm,csi-data-bus-width: data bus width (valid values are 8 and 16)
14 - ifm,csi-wait-cycles: sensor bus wait cycles
17 - ifm,csi-byte-swap: if this property is present, the byte swapping on
23 		compatible = "ifm,o2d-csi";
24 		reg = <3 0 0x00100000>;		/* CS 3, 1 MiB range */
27 		ifm,csi-clk-handle = <&timer7>;
28 		gpios = <&gpio_simple 23 0	/* image_capture */
32 		ifm,csi-addr-bus-width = <24>;
33 		ifm,csi-data-bus-width = <8>;
34 		ifm,csi-wait-cycles = <0>;