Lines Matching +full:sync +full:- +full:2
1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Nuno Sá <nuno.sa@analog.com>
14 https://www.analog.com/media/en/technical-documentation/data-sheets/ADIS16475.pdf
19 - adi,adis16475-1
20 - adi,adis16475-2
21 - adi,adis16475-3
22 - adi,adis16477-1
23 - adi,adis16477-2
24 - adi,adis16477-3
25 - adi,adis16470
26 - adi,adis16465-1
27 - adi,adis16465-2
28 - adi,adis16465-3
29 - adi,adis16467-1
30 - adi,adis16467-2
31 - adi,adis16467-3
32 - adi,adis16500
33 - adi,adis16501
34 - adi,adis16505-1
35 - adi,adis16505-2
36 - adi,adis16505-3
37 - adi,adis16507-1
38 - adi,adis16507-2
39 - adi,adis16507-3
40 - adi,adis16575-2
41 - adi,adis16575-3
42 - adi,adis16576-2
43 - adi,adis16576-3
44 - adi,adis16577-2
45 - adi,adis16577-3
50 spi-cpha: true
52 spi-cpol: true
54 spi-max-frequency:
57 spi-cs-inactive-delay-ns:
67 reset-gpios:
74 adi,sync-mode:
76 Configures the device SYNC pin. The following modes are supported
77 0 - output_sync
78 1 - direct_sync
79 2 - scaled_sync
80 3 - pulse_sync
86 - compatible
87 - reg
88 - interrupts
89 - spi-cpha
90 - spi-cpol
93 - $ref: /schemas/spi/spi-peripheral-props.yaml#
94 - if:
99 - adi,adis16500
100 - adi,adis16501
101 - adi,adis16505-1
102 - adi,adis16505-2
103 - adi,adis16505-3
104 - adi,adis16507-1
105 - adi,adis16507-2
106 - adi,adis16507-3
107 - adi,adis16575-2
108 - adi,adis16575-3
109 - adi,adis16576-2
110 - adi,adis16576-3
111 - adi,adis16577-2
112 - adi,adis16577-3
116 adi,sync-mode:
118 maximum: 2
120 - if:
122 adi,sync-mode:
123 enum: [1, 2, 3]
127 adi,sync-mode: [ clocks ]
129 - if:
134 - adi,adis16575-2
135 - adi,adis16575-3
136 - adi,adis16576-2
137 - adi,adis16576-3
138 - adi,adis16577-2
139 - adi,adis16577-3
143 spi-max-frequency:
149 - |
150 #include <dt-bindings/interrupt-controller/irq.h>
152 #address-cells = <1>;
153 #size-cells = <0>;
155 adis16475: adis16475-3@0 {
156 compatible = "adi,adis16475-3";
158 spi-cpha;
159 spi-cpol;
160 spi-max-frequency = <2000000>;
162 interrupt-parent = <&gpio>;