Lines Matching +full:gpio3 +full:- +full:monitor +full:- +full:enable

1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10   - Nuno Sa <nuno.sa@analog.com>
15   https://www.analog.com/media/en/technical-documentation/data-sheets/ltc4282.pdf
20       - adi,ltc4282
25   vdd-supply: true
30   '#clock-cells':
33   adi,rsense-nano-ohms:
36   adi,vin-mode-microvolt:
43   adi,fet-bad-timeout-ms:
46       wait time/timeout for a FET-bad fault to be signaled. Setting this to 0,
51   adi,overvoltage-dividers:
63   adi,undervoltage-dividers:
75   adi,current-limit-sense-microvolt:
83   adi,overcurrent-retry:
85       If set, enables the chip to auto-retry 256 timer cycles after an
89   adi,overvoltage-retry-disable:
91       If set, disables the chip to auto-retry 50ms after an Overvoltage fault.
95   adi,undervoltage-retry-disable:
97       If set, disables the chip to auto-retry 50ms after an Undervoltage fault.
101   adi,fault-log-enable:
106       the EE_FAULT_LOG register - the one in EEPROM - into FAULT_LOG at boot).
109   adi,gpio1-mode:
112       into high-z when power is not good).
117   adi,gpio2-mode:
124   adi,gpio3-monitor-enable:
125     description: If set, gpio3 is set as input for the ADC instead of gpio2.
129   - if:
131         - adi,gpio3-monitor-enable
134         adi,gpio2-mode:
138   - compatible
139   - reg
140   - adi,rsense-nano-ohms
145   - |
147         #address-cells = <1>;
148         #size-cells = <0>;
153             adi,rsense-nano-ohms = <500>;
155             adi,gpio1-mode = "power_good";
156             adi,gpio2-mode = "adc_input";