Lines Matching full:an
42 * A section of an FPGA is reprogrammed while the rest of the FPGA is not
48 * A PRR is a specific section of an FPGA reserved for reconfiguration.
59 * An FPGA image that is designed to be loaded into a PRR. There may be
68 * FPGA bridges may be actual hardware or soft logic on an FPGA.
76 * An FPGA image may create a set of reprogrammable regions, each having its
80 * An FPGA Manager is a hardware block that programs an FPGA under the control
85 * An FPGA image that is designed to do full reconfiguration of the FPGA.
106 Figure 1: An FPGA set up with a base image that created three regions. Each
115 When a DT overlay that targets an FPGA Region is applied, the FPGA Region will
131 FPGA Regions represent FPGA's and FPGA PR regions in the device tree. An FPGA
140 The intended use is that a Device Tree overlay (DTO) can be used to reprogram an
141 FPGA while an operating system is running.
143 An FPGA Region that exists in the live Device Tree reflects the current state.
144 If the live tree shows a "firmware-name" property or child nodes under an FPGA
145 Region, the FPGA already has been programmed. A DTO that targets an FPGA Region
151 reconfiguration. It must include a phandle to an FPGA Manager. The base
157 For partial reconfiguration (PR), each PR region will have an FPGA Region.
162 If an FPGA Region does not specify an FPGA Manager, it will inherit the FPGA
164 where the same FPGA Manager is used for all of an FPGA as well the case where
179 uses are specific to an FPGA device.
200 PRR's with FPGA bridges. The device tree should have an FPGA region for each
254 Should contain the name of an FPGA image file located on the firmware
257 If this property is in an overlay targeting an FPGA region, it is
266 If the fpga-region is the child of an fpga-bridge, the list should not
272 Should contain a phandle to an FPGA Manager. Child FPGA Regions
273 inherit this property from their ancestor regions. An fpga-mgr property