Lines Matching +full:8 +full:khz
166 selectable by dmesg is 8.
184 the log level is 8 or more (their level doesn't matter). Before stack
186 at least 8 can also be set by the "debug" command line option (see
187 2.3) and at run time with "dmesg -n 8".
192 built-in serial port; parameters: 9600bps, 8N1
201 ST-MFP serial port ("Modem1"); parameters: 9600bps, 8N1
203 SCC channel B serial port ("Modem2"); parameters: 9600bps, 8N1
208 The MIDI port; parameters: 31250bps, 8N1
282 be scanned. Valid values for <n> are between 1 and 8. Default is 8 if
455 planes of one pixel; this is the most common mode for 8 planes
500 value is 8.
521 4.1.8) monitorcap:
532 the horizontal frequency, in kHz.
611 don't make sense. Default: 16/8.
619 32). Default: 8/1. (Note: Values > 1 seem to cause problems on a
727 - ntsc : 640x200, 15 kHz, 60 Hz
728 - ntsc-lace : 640x400, 15 kHz, 60 Hz interlaced
731 - pal : 640x256, 15 kHz, 50 Hz
732 - pal-lace : 640x512, 15 kHz, 50 Hz interlaced
735 - multiscan : 640x480, 29 kHz, 57 Hz
736 - multiscan-lace : 640x960, 29 kHz, 57 Hz interlaced
737 - euro36 : 640x200, 15 kHz, 72 Hz
738 - euro36-lace : 640x400, 15 kHz, 72 Hz interlaced
739 - euro72 : 640x400, 29 kHz, 68 Hz
740 - euro72-lace : 640x800, 29 kHz, 68 Hz interlaced
741 - super72 : 800x300, 23 kHz, 70 Hz
742 - super72-lace : 800x600, 23 kHz, 70 Hz interlaced
743 - dblntsc-ff : 640x400, 27 kHz, 57 Hz
744 - dblntsc-lace : 640x800, 27 kHz, 57 Hz interlaced
745 - dblpal-ff : 640x512, 27 kHz, 47 Hz
746 - dblpal-lace : 640x1024, 27 kHz, 47 Hz interlaced
747 - dblntsc : 640x200, 27 kHz, 57 Hz doublescan
748 - dblpal : 640x256, 27 kHz, 47 Hz doublescan
751 - vga : 640x480, 31 kHz, 60 Hz
752 - vga70 : 640x400, 31 kHz, 70 Hz
756 chipset and 8-bit color for the AGA chipset.
791 the horizontal frequency, in kHz.
860 8 through 20. The default value depends on your hostadapter(s),
861 default for the A3000 internal controller is 14, for the A2091 it's 8
862 and for the GVP hostadapters it's either 8 or 14, depending on the