Lines Matching full:synthesizer

31 user is using a hardware synthesizer, then Speakup will be able to
43 specific synthesizer by default, then all you need to do to use Speakup
45 assumes of course  that your synthesizer is a supported hardware
46 synthesizer, and that it is either installed in or connected to your
50 kernel with no default synthesizer.  It is even possible that your
53 your synthesizer is supported but not available, complain to the person
59 synthesizer set, or you would like to use a different synthesizer than
66 DoubleTalk LT at boot up.  You may replace the ltlk synthesizer keyword
67 with the keyword for whatever synthesizer you wish to use.  The
96 By default speakup looks for the synthesizer on the ttyS0 serial port. This can
113 proper bootup parameter for your synthesizer, Speakup will begin
427 driver for the software synthesizer.  If you use the LiteTalk, your
428 synthesizer-specific settings would be found in /speakup/ltlk.  In other words,
511 number of the driver for the current synthesizer.
518 # Replace KWD with the keyword for your synthesizer, E.G., ltlk for LiteTalk.
521 The number five which comes back is the level at which the synthesizer
534 It is possible to change to a different synthesizer while speakup is
536 in order to use a different synthesizer.  You can simply echo the
537 synthesizer keyword to the /speakup/synth sys entry.
539 sys entry, to disable speech while one synthesizer is disconnected and
541 new synthesizer into the synth sys entry in order to start speech
542 with the newly connected synthesizer.  See the list of synthesizer
560 the synthesizer driver you wish to use.  The driver modules are all
562 synthesizer you want.  So, in order to load the driver for the DecTalk
594 of by simply echoing the synthesizer keyword into the
609 Using a software synthesizer requires that some other software be
621 software synthesizer, you must have created the /dev/softsynth device.
629 synthesizer.  To create /dev/synth, change to the /dev directory, and
638 Espeakup is a connector between Speakup and the eSpeak software synthesizer.
693 chosen software synthesizer, you still need one more piece of software
697 your software synthesizer.
699 Now you can begin using your software synthesizer.  In order to do so,
743 will accept a number from 0 through 7 for the DecTalk PC synthesizer,
979 and they could not be changed.  If you used a non-English synthesizer,
1207 Talkwith allows you to switch synthesizers on the fly.  It takes a synthesizer
1211 software synthesizer, you must also indicate which daemon you wish to
1225 synthesizer is activated.  You can use speakupconf to load your settings