Lines Matching +full:dual +full:- +full:link
1 .. SPDX-License-Identifier: GPL-2.0
8 Copyright |copy| 2023 - 2025 Digiteq Automotive
12 card capable of capturing and generating FPD-Link III and GMSL2/3 video streams
16 ---------------
22 There are two types of parameters - global / PCI card related, found under
32 | 0 - No module present
33 | 1 - FPDL3
34 | 2 - GMSL (one serializer, two daisy chained deserializers)
35 | 3 - GMSL (one serializer, two deserializers)
36 | 4 - GMSL (two deserializers with two daisy chain outputs)
44 | 1 - FPDL3
45 | 2 - GMSL
53 PRODUCT-REVISION-SERIES-SERIAL
66 | 0 - single
67 | 1 - dual (default)
72 | 0 - OLDI/JEIDA
73 | 1 - SPWG/VESA (default)
76 Video link status. If the link is locked, chips are properly connected and
77 communicating at the same speed and protocol. The link can be locked without
83 | 0 - unlocked
84 | 1 - locked
87 Video stream status. A stream is detected if the link is locked, the input
93 | 0 - not detected
94 | 1 - detected
114 | 0 - active low
115 | 1 - active high
116 | 2 - not available
124 | 0 - active low
125 | 1 - active high
126 | 2 - not available
196 "dual".
198 | 0 - PLL < 50MHz (default)
199 | 1 - PLL >= 50MHz
216 | 0 - input 0
217 | 1 - input 1
218 | 2 - v4l2 output 0
219 | 3 - v4l2 output 1
252 | 0 - active low (default)
253 | 1 - active high
258 | 0 - active low (default)
259 | 1 - active high
264 | 0 - active low
265 | 1 - active high (default)
268 Output pixel clock frequency. Allowed values are between 25000-190000(kHz)
269 and there is a non-linear stepping between two consecutive allowed
306 | 0 - auto (default)
307 | 1 - single
308 | 2 - dual
316 | 0 - auto (default)
317 | 1 - single
318 | 2 - dual
326 | 0 - 12Gb/s (default)
327 | 1 - 6Gb/s
328 | 2 - 3Gb/s
329 | 3 - 1.5Gb/s
332 The GMSL multi-stream contains up to four video streams. This parameter
334 zero-based index of the stream. The default stream id is 0.
342 | 0 - disabled
343 | 1 - enabled (default)
346 --------------
349 - mgb4-fw.X - FPGA firmware.
350 - mgb4-data.X - Factory settings, e.g. card serial number.
352 The *mgb4-fw* partition is writable and is used for FW updates, *mgb4-data* is
353 read-only. The *X* attached to the partition name represents the card number.
355 also have a third partition named *mgb4-flash* available in the system. This
360 --------------
368 | bit 1 - trigger 1 pending
369 | bit 2 - trigger 2 pending
370 | bit 5 - trigger 1 level
371 | bit 6 - trigger 2 level
385 buffer mode - the values do not represent valid data in such case.*