Lines Matching refs:HDMI
4 HDMI CEC
10 HDMI Transmitters:
14 - STIH4xx HDMI CEC
32 HDMI Receivers:
50 - Extron DA HD 4K PLUS HDMI Distribution Amplifier. See
90 the HDMI wikipedia page: https://en.wikipedia.org/wiki/HDMI. CEC is part
91 of the HDMI specification. HDMI 1.3 is freely available (very similar to
92 HDMI 1.4 w.r.t. CEC) and should be good enough for most things.
95 DisplayPort to HDMI Adapters with working CEC
108 To test: hook up your DP-to-HDMI adapter to a CEC capable device
121 USB-C to HDMI
130 DisplayPort to HDMI
137 HP DisplayPort to HDMI True 4k Adapter (P/N 2JA63AA): https://www.hp.com/us-en/shop/pdp/hp-displayp…
139 Mini-DisplayPort to HDMI
227 Some displays when in standby mode have no HDMI Hotplug Detect signal, but
247 1) Get a Pulse-Eight USB CEC dongle, connect an HDMI cable from your
279 two HDMI outputs together. You won't have a HPD (which is what we
315 The critical component is one of these HDMI female-female passthrough connectors
336 The ground pin of the HDMI connector needs to be connected to a ground
339 The CEC pin of the HDMI connector needs to be connected to these pins:
340 GPIO 6 and GPIO 7. The optional HPD pin of the HDMI connector should
342 The optional 5V pin of the HDMI connector should be connected via the
372 The minimum configuration is one HDMI female-female passthrough connector
373 and two female-female breadboard wires: one for connecting the HDMI ground
374 pin to a ground pin on the Raspberry Pi, and the other to connect the HDMI
391 This driver is for the Extron DA HD 4K PLUS series of HDMI Distribution
403 to manually control CEC for the HDMI Input and all HDMI Outputs. While this gives
414 read the EDIDs and (for the HDMI Input port) to set the EDID.
416 By default userspace is responsible to set the EDID for the HDMI Input
419 of the HDMI Input based on the supported resolutions of the connected displays.
421 displays support 4kp60, then it will advertise 4kp60 on the HDMI input, otherwise
439 on the input to the HDMI outputs. This is done for the following CEC messages:
448 configure the CEC devices for HDMI Input and the HDMI Outputs manually.
453 A three character manufacturer name that is used in the EDID for the HDMI
457 anymore to manually set the EDID for the HDMI Input.
462 If set, then the Hotplug Detect pin of the HDMI Input will always be high,
463 even if nothing is connected to the HDMI Outputs. If not set (the default)
464 then the Hotplug Detect pin of the HDMI input will go low if all the detected
465 Hotplug Detect pins of the HDMI Outputs are also low.