Lines Matching +full:temperature +full:- +full:enable

5 		(RW) read or write TH and TL (Temperature High an Low) alarms.
7 		(typical -55 degC to 125 degC), if not values will be trimmed
11 		master level, refer to Documentation/w1/w1-generic.rst for
41 			* '-xx': xx is kernel error when reading power status
55 		values after power-on. Read or write are :
59 			* '-xx': xx is kernel error when reading the resolution
62 		Some DS18B20 clones are fixed in 12-bit resolution, so the
69 What:		/sys/bus/w1/devices/.../temperature
73 		(RO) return the temperature in 1/1000 degC.
76 			  return the temperature computed when the bulk read
94 		(RW) return the temperature in 1/1000 degC.
96 		bus, return the CRC check and temperature in 1/1000 degC
118 			* '-1':
124 				no bulk operation. Reading temperature will
132 		immediately, the next access to temperature on this device
133 		will return the temperature measured at the time of issue
134 		of the bulk read command (not the current temperature).
143 		(RW) Get, set, or measure a temperature conversion time. The
156 			     temperature conversion, measure an actual value.
157 			     Increase it by 20% for temperature range. A new
174                  1 Enable check for conversion success. If byte 6 of
176                    temperature reads 85.00 (powerup value) or 127.94
177                    (insufficient power) - return a conversion error.
179                 2  Enable poll for conversion completion. Generate read cycles