Lines Matching +full:in +full:- +full:application

6 		Values shall be space separated and in the device range
7 		(typical -55 degC to 125 degC), if not values will be trimmed
9 		stored in a 8bit register in the device. Lowest value is
11 		master level, refer to Documentation/w1/w1-generic.rst for
13 Users:		any user space application which wants to communicate with
23 		embedded in device EEPROM. Be aware that devices support
27 			* 'restore': restore EEPROM data in device RAM
29 Users:		any user space application which wants to communicate with
41 			* '-xx': xx is kernel error when reading power status
43 Users:		any user space application which wants to communicate with
53 		will be changed only in device RAM, so it will be cleared when
55 		values after power-on. Read or write are :
57 			* '9..14': device resolution in bit
58 			  or resolution to set in bit
59 			* '-xx': xx is kernel error when reading the resolution
62 		Some DS18B20 clones are fixed in 12-bit resolution, so the
65 Users:		any user space application which wants to communicate with
73 		(RO) return the temperature in 1/1000 degC.
83 			  device support this feature). It takes 94ms in 9bits
86 Users:		any user space application which wants to communicate with
94 		(RW) return the temperature in 1/1000 degC.
96 		bus, return the CRC check and temperature in 1/1000 degC
101 			* '9..14' : set the device resolution in RAM
107 Users:		any user space application which wants to communicate with
118 			* '-1':
119 				conversion in progress on at least 1 sensor
135 Users:		any user space application which wants to communicate with
149 			Actual conversion time in milliseconds.
161 			     Set the conversion time in milliseconds.
163 Users:		An application using the w1_term device
177                    (insufficient power) - return a conversion error.
180                    after the conversion start and wait for 1's. In parasite
190 Users:		An application using the w1_term device