Lines Matching +full:flash +full:- +full:led

1 What:		/sys/class/leds/<led>/flash_brightness
6 		Set the brightness of this LED in the flash strobe mode, in
7 		microamperes. The file is created only for the flash LED devices
8 		that support setting flash brightness.
11 		/sys/class/leds/<led>/max_flash_brightness.
13 What:		/sys/class/leds/<led>/max_flash_brightness
18 		Maximum brightness level for this LED in the flash strobe mode,
21 What:		/sys/class/leds/<led>/flash_timeout
26 		Hardware timeout for flash, in microseconds. The flash strobe
28 		of the strobe. The file is created only for the flash LED
29 		devices that support setting flash timeout.
31 What:		/sys/class/leds/<led>/max_flash_timeout
36 		Maximum flash timeout for this LED, in microseconds.
38 What:		/sys/class/leds/<led>/flash_strobe
43 		Flash strobe state. When written with 1 it triggers flash strobe
44 		and when written with 0 it turns the flash off.
46 		On read 1 means that flash is currently strobing and 0 means
47 		that flash is off.
49 What:		/sys/class/leds/<led>/flash_fault
54 		Space separated list of flash faults that may have occurred.
55 		Flash faults are re-read after strobing the flash. Possible
56 		flash faults:
58 		* led-over-voltage
59 			flash controller voltage to the flash LED
60 			has exceeded the limit specific to the flash controller
61 		* flash-timeout-exceeded
62 			the flash strobe was still on when
63 			the timeout set by the user has expired; not all flash
65 		* controller-over-temperature
66 			the flash controller has
68 		* controller-short-circuit
70 			of the flash controller has been triggered
71 		* led-power-supply-over-current
72 			current in the LED power
73 			supply has exceeded the limit specific to the flash
75 		* indicator-led-fault
76 			the flash controller has detected
77 			a short or open circuit condition on the indicator LED
78 		* led-under-voltage
79 			flash controller voltage to the flash
80 			LED has been below the minimum limit specific to
81 			the flash
82 		* controller-under-voltage
83 			the input voltage of the flash
85 			flash at full current will not be possible;
87 		* led-over-temperature
88 			the temperature of the LED has exceeded