Lines Matching +full:high +full:- +full:z +full:- +full:input
3 Contact: linux-iio@vger.kernel.org
11 Contact: linux-iio@vger.kernel.org
16 MTCLKA-MTCLKB:
20 MTCLKC-MTCLKD:
26 Contact: linux-iio@vger.kernel.org
33 Contact: linux-iio@vger.kernel.org
39 Contact: linux-iio@vger.kernel.org
45 Contact: linux-iio@vger.kernel.org
52 Contact: linux-iio@vger.kernel.org
59 Contact: linux-iio@vger.kernel.org
78 non-recycle:
80 underflow takes place. The counter is re-enabled when a
84 modulo-n:
96 goes high and remains high until a new preset value is
99 hardware retriggerable one-shot:
100 The output signal is initially high. The output signal
101 will go low by a trigger input signal, and will remain
103 go high and remain high until the next trigger. A
106 the one-shot pulse.
109 The output signal is initially high. When the counter
111 clock pulse. The output signal then goes high again, the
116 The output signal is initially high.
130 the count expires, the output goes high again and the
135 The output signal is initially high. When the count
137 then go high again. The counting sequence is "triggered"
141 The output signal is initially high. Counting is started
142 by a trigger input signal. When the count expires, the
144 go high again. A trigger results in loading the counter
153 Contact: linux-iio@vger.kernel.org
161 Contact: linux-iio@vger.kernel.org
163 Read-only attribute that indicates the count direction of Count
174 Contact: linux-iio@vger.kernel.org
188 Contact: linux-iio@vger.kernel.org
190 Read-only attribute that indicates whether excessive noise is
195 Contact: linux-iio@vger.kernel.org
207 pulse-direction:
209 The input level of signal B determines direction.
242 Contact: linux-iio@vger.kernel.org
244 Read-only attribute that indicates the device-specific name of
250 Contact: linux-iio@vger.kernel.org
259 Contact: linux-iio@vger.kernel.org
261 If the counter device supports preset registers -- registers
262 used to load counter channels to a set count upon device-defined
263 preset operation trigger events -- the preset count for channel
268 Contact: linux-iio@vger.kernel.org
275 Contact: linux-iio@vger.kernel.org
277 Action mode of Count Y for Signal Z. This attribute indicates
278 the condition of Signal Z that triggers the count function
284 Pulse-Direction count function mode, this Signal is
288 Low state transitions to high state.
291 High state transitions to low state.
298 Contact: linux-iio@vger.kernel.org
324 Contact: linux-iio@vger.kernel.org
326 Read-only attribute that indicates the component ID of the
331 Contact: linux-iio@vger.kernel.org
340 Contact: linux-iio@vger.kernel.org
344 rounded-up to a power of 2.
348 Contact: linux-iio@vger.kernel.org
350 Read-only attribute that indicates the device-specific name of
356 Contact: linux-iio@vger.kernel.org
358 Read-only attribute that indicates the total number of Counts
363 Contact: linux-iio@vger.kernel.org
365 Read-only attribute that indicates the total number of Signals
370 Contact: linux-iio@vger.kernel.org
372 Read-only attribute that indicates whether a differential
380 Contact: linux-iio@vger.kernel.org
388 Contact: linux-iio@vger.kernel.org
390 Filter clock factor for input Signal Y. This prescaler value
395 Contact: linux-iio@vger.kernel.org
397 Active level of index input Signal Y; irrelevant in
398 non-synchronous load mode.
403 Contact: linux-iio@vger.kernel.org
410 Contact: linux-iio@vger.kernel.org
416 Signal high state considered active level (rising edge).
423 Contact: linux-iio@vger.kernel.org
425 Read-only attribute that indicates the device-specific name of
431 Contact: linux-iio@vger.kernel.org
439 high:
440 High level state.
444 Contact: linux-iio@vger.kernel.org
447 non-synchronous or synchronous load mode. Synchronous load mode
448 cannot be selected in non-quadrature (Pulse-Direction) clock
451 non-synchronous:
453 input. The index function (as enabled via preset_enable)
455 input.
462 quadrature clock on the active level of the index input.
466 Contact: linux-iio@vger.kernel.org
468 Read-only attribute that indicates the signal Y frequency, in Hz.