Lines Matching +full:suspend +full:- +full:to +full:- +full:ram

2 # NOTES -- Lines that can be cut/pasted into kernel and hints configs.
26 # for the MP Table case.  However, we shouldn't try to guess and use
32 # IPI_PREEMPTION instructs the kernel to preempt threads running on other
47 # You must specify at least one CPU (the one you intend to run on);
48 # deleting the specification for CPUs you don't need to use may make
58 # CPU_ATHLON_SSE_HACK tries to enable SSE instructions when the BIOS has
59 # forgotten to enable them.
61 # CPU_BLUELIGHTNING_3X enables triple-clock mode on IBM Blue Lightning
62 # CPU if CPU supports it.  The default is double-clock mode on
76 # mapped mode.  Default is 2-way set associative mode.
87 # technology which allows to restrict power consumption of the CPU by
111 # is useful when you use Socket 8 to Socket 370 converter, because most Pentium
118 # CPU_SUSP_HLT enables suspend on HALT.  If this option is set, CPU
119 # enters suspend mode following execution of HALT instruction.
124 # K5/K6/K6-2 CPUs.
130 # without cache flush at hold state, and (2) write-back CPU cache on
136 # and should be included for any non-Pentium CPU that defines it.
139 # which indicates that the 15-16MB range is *definitely* not being
147 # in write-through mode when revision < 2.7.  If revision of Cyrix
148 # 6x86 >= 2.7, CPU cache is always enabled in write-back mode.
151 # locked cycles in order to operate correctly.
184 # to be compiled.  See perfmon(4) for more information.
189 # Hints for the non-optional Numeric Processing eXtension driver.
195 #	0x01	don't use the npx registers to optimize bcopy.
196 #	0x02	don't use the npx registers to optimize bzero.
197 #	0x04	don't use the npx registers to optimize copyin or copyout.
198 # The npx registers are normally used to optimize copying and zeroing when
204 # Then copying and zeroing using the npx registers is normally 30-100% faster.
205 # The flags can be used to control cases where it doesn't work or is slower.
221 # the /dev/3dfx0 device to work with glide implementations.  This should get
222 # linked to /dev/3dfx and /dev/voodoo.  Note that this is not the same as
225 # To enable Linuxulator support, one must also load linux.ko and tdfx_linux.ko.
242 # sbni: Granch SBNI12-xx ISA and PCI adapters
255 # Hint for the i386-only ISA front-end of le(4).
294 # pcf:	Philips PCF8584 ISA-bus controller
311 # Enable (32-bit) a.out binary support
319 # stop panics related to heavy use of shared memory.  However, that can
323 # If you're tweaking this, you might also want to increase the sysctls
332 # This number should include enough pages to map the kernel, any
339 # KSTACK_PAGES is the number of memory pages to assign to the kernel