Merge branch 'dt/schema-cleanups' into dt/linus

dt-bindings: Fix more incorrect 'reg' property sizes in examples

The examples template is a 'simple-bus' with a size of 1 cell for
had between 2 and 4 cells which really only errors on I2C or SPI ty

dt-bindings: Fix more incorrect 'reg' property sizes in examples

The examples template is a 'simple-bus' with a size of 1 cell for
had between 2 and 4 cells which really only errors on I2C or SPI type
devices with a single cell.

The easiest fix in most cases is to change the 'reg' property to 1 cell
for address and size.

Cc: "Heiko Stübner" <heiko@sntech.de>
Cc: Ezequiel Garcia <ezequiel@collabora.com>
Cc: Mauro Carvalho Chehab <mchehab@kernel.org>
Cc: Philipp Zabel <p.zabel@pengutronix.de>
Cc: Miquel Raynal <miquel.raynal@bootlin.com>
Cc: Richard Weinberger <richard@nod.at>
Cc: "David S. Miller" <davem@davemloft.net>
Cc: Bjorn Andersson <bjorn.andersson@linaro.org>
Cc: Kishon Vijay Abraham I <kishon@ti.com>
Cc: Vinod Koul <vkoul@kernel.org>
Cc: Liam Girdwood <lgirdwood@gmail.com>
Cc: linux-rockchip@lists.infradead.org
Cc: linux-media@vger.kernel.org
Cc: linux-mtd@lists.infradead.org
Cc: netdev@vger.kernel.org
Cc: alsa-devel@alsa-project.org
Acked-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Rob Herring <robh@kernel.org>

show more ...

Merge branch 'x86/entry' into ras/core

to fixup conflicts in arch/x86/kernel/cpu/mce/core.c so MCE specific follow
up patches can be applied without creating a horrible merge conflict
afterwards.

Merge tag 'arm-drivers-5.8' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

Pull ARM/SoC driver updates from Arnd Bergmann:
"These are updates to SoC specific drivers that did not have ano

Merge tag 'arm-drivers-5.8' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

Pull ARM/SoC driver updates from Arnd Bergmann:
"These are updates to SoC specific drivers that did not have another
subsystem maintainer tree to go through for some reason:

- Some bus and memory drivers for the MIPS P5600 based Baikal-T1 SoC
that is getting added through the MIPS tree.

- There are new soc_device identification drivers for TI K3, Qualcomm
MSM8939

- New reset controller drivers for NXP i.MX8MP, Renesas RZ/G1H, and
Hisilicon hi6220

- The SCMI firmware interface can now work across ARM SMC/HVC as a
transport.

- Mediatek platforms now use a new driver for their "MMSYS" hardware
block that controls clocks and some other aspects in behalf of the
media and gpu drivers.

- Some Tegra processors have improved power management support,
including getting woken up by the PMIC and cluster power down
during idle.

- A new v4l staging driver for Tegra is added.

- Cleanups and minor bugfixes for TI, NXP, Hisilicon, Mediatek, and
Tegra"

* tag 'arm-drivers-5.8' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (155 commits)
clk: sprd: fix compile-testing
bus: bt1-axi: Build the driver into the kernel
bus: bt1-apb: Build the driver into the kernel
bus: bt1-axi: Use sysfs_streq instead of strncmp
bus: bt1-axi: Optimize the return points in the driver
bus: bt1-apb: Use sysfs_streq instead of strncmp
bus: bt1-apb: Use PTR_ERR_OR_ZERO to return from request-regs method
bus: bt1-apb: Fix show/store callback identations
bus: bt1-apb: Include linux/io.h
dt-bindings: memory: Add Baikal-T1 L2-cache Control Block binding
memory: Add Baikal-T1 L2-cache Control Block driver
bus: Add Baikal-T1 APB-bus driver
bus: Add Baikal-T1 AXI-bus driver
dt-bindings: bus: Add Baikal-T1 APB-bus binding
dt-bindings: bus: Add Baikal-T1 AXI-bus binding
staging: tegra-video: fix V4L2 dependency
tee: fix crypto select
drivers: soc: ti: knav_qmss_queue: Make knav_gp_range_ops static
soc: ti: add k3 platforms chipid module driver
dt-bindings: soc: ti: add binding for k3 platforms chipid module
...

show more ...

Merge branch 'baikal/drivers' into arm/drivers

[arnd: This is a patch series from Serge Semin to add a few drivers
that don't have any other subsystem maintainer tree to go through,
so I'm picking

Merge branch 'baikal/drivers' into arm/drivers

[arnd: This is a patch series from Serge Semin to add a few drivers
that don't have any other subsystem maintainer tree to go through,
so I'm picking them up through the soc tree, full series description
from the mailing list below]

Baikal-T1 SoC CPU is based on two MIPS Warrior P5600 cores. Their main
memory Non-Coherent IO interface is connected to the OCP2AXI bridge,
which in turn is then connected to the DW AMBA 3 AXI Interconnect (so
called Main Interconnect) with nine masters and four slaves ports. Main
Interconnect is responsible for the AXI-bus traffic arbitration (QoS)
and its routing from one component to another. In addition there is
a Errors Handler Block (EHB) accesible by means of the Baikal-T1 SoC
System Controller responsible to detect AXI protocol errors and device
not responding situations built on top the interconnect. Baikal-T1 AXI-bus
driver included in this patchset will be responsible for working with that
functionality, though currently it doesn't support QoS tuning. Instead
it's capable of detecting the error events, reporting an info about
them to the system log, injecting artificial errors to test the driver
functionality. Since AXI Interconnect doesn't provide a way to find
out which devices are connected to it, so its DT node is supposed to
be compatible with "simple-bus" driver, while sub-nodes shall represent
the masters attached to the bus.

One of the AXI Interconnect slaves is an AXI-APB bridge used to access the
Baikal-T1 SoC subsystems CSRs. MMIO request from CPU and DMAC masters are
routed there if they are detected to be within [0x08000000 0x1FFFFFFF]
range of the physical memory. In case if an attempted APB transaction
stays with no response for a pre-defined time it will be detected by
the APB-bus Errors Handler Block (EHB), which will raise an interrupt,
then the bus gets freed for a next operation. The APB-bus driver provides
the interrupt handler to detect the erroneous address, update an errors
counter and prints an error message about the faulty address. The counter
and the APB-bus operations timeout can be accessed via corresponding sysfs
nodes. A dedicated sysfs-node can be also used to artificially cause the
bus errors described above. Since APB-bus is a platform bus, it doesn't
provide a way to detect slave devices connected to it, so similarly to
the AXI-bus it's also supposed to be compatible with "simple-bus" driver.

Aside from PCIe/SATA/DDR/I2C/EHB/CPU/reboot specific settings the
Baikal-T1 System Controller provides a MIPS P5600 CM2 L2-cache tuning
block. It is responsible for the setting up the Tag/Data/WS L2-to-RAM
latencies. The last small patch in this patchset provides a driver and
DT-schema-based binding for the described device. So that the latencies
can be tuned up by means of dedicated DT properties and sysfs nodes.

This patchset is rebased and tested on the mainline Linux kernel
5.7-rc4.

Changelog v2 (AXI/APB bus):
- Assign dual GPL/BSD licenses to the bindings.
- Use single lined copyright headers in the bindings.
- Replace "additionalProperties: false" property with
"unevaluatedProperties: false" in the bindings.
- Don't use a multi-arg clock phandle reference in DT binding examples.
Thus remove includes from there.
- Fix some commit message and Kconfig help text spelling.
- Move drivers from soc to the bus subsystem.
- Convert a simple EHB drivers to the Baikal-T1 AXI and APB bus ones.
- Convert APB bus driver to using regmap MMIO API.
- Use syscon regmap to access the AXI-bus erroneous address.
- Add reset line support.
- Add Main Interconnect clock support to the AXI-bus driver.
- Remove probe-status info string printout.
- Discard of_match_ptr() macro utilization.
- Don't print error-message if no platform IRQ found. Just return an
error.
- Use generic FIELD_{GET,PREP} macros instead of handwritten ones in the
AXI-bus driver.

Changelog v2 (l2 driver):
- Fix some commit message and Kconfig help text spelling.
- Move the driver to the memory subsystem.
- Assign dual GPL/BSD license to the DT binding.
- Use single lined copyright header in the binding.
- Discard reg property and syscon compatible string.
- Move "allOf" restrictions to the root level of the properties.
- The DT node is supposed to be a child of the Baikal-T1 system
controller node. So regmap will be fetched from there.
- Use generic FIELD_{GET,PREP} macro.
- Remove probe-status info string printout.
- Since the driver depends on the OF config we can remove of_match_ptr()
macro utilization.

Changelog v3:
- Combine l2 and AXI/APB bus patches in a single patchset.
- Retrieve AXI-bus QoS registers by resource name "qos".
- Discard CONFIG_OF dependency since there is none at compile-time.
- Add syscon EHB registers range to the AXI-bus reg property as optional
entry.
- Fix invalid of_property_read_u32() return value test in the l2-ctl
driver.
- Get the reg property back into the l2-ctl DT bindings even though the
driver is using the parental syscon regmap.
- The l2-ctl DT schema will live separately from the system controller,
but the corresponding sub-node of the later DT schema will $ref this
one.
- Set non-default latencies in the l2-ctl DT example.

* baikal/drivers:
memory: Add Baikal-T1 L2-cache Control Block driver
bus: Add Baikal-T1 APB-bus driver
bus: Add Baikal-T1 AXI-bus driver
dt-bindings: bus: Add Baikal-T1 APB-bus binding
dt-bindings: bus: Add Baikal-T1 AXI-bus binding

Link: https://lore.kernel.org/lkml/20200526130841.ap6qlxv7hqmabnh5@mobilestation/
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

show more ...

dt-bindings: bus: Add Baikal-T1 APB-bus binding

Baikal-T1 CPU or DMAC MMIO requests are handled by the AMBA 3 AXI
Interconnect which routes them to the AXI-APB bridge, which in turn
serializes acces

dt-bindings: bus: Add Baikal-T1 APB-bus binding

Baikal-T1 CPU or DMAC MMIO requests are handled by the AMBA 3 AXI
Interconnect which routes them to the AXI-APB bridge, which in turn
serializes accesses and routes them to the corresponding APB slave device.
This binding describes the AXI-APB bridge considered as the APB-bus. It is
supposed to be compatible with "be,bt1-apb" and "simple-bus" drivers,
should be equipped with EHB MMIO region and a region with no slave device
mapped, interrupts line number, APB reference clock and domain reset line.

Link: https://lore.kernel.org/r/20200526125928.17096-3-Sergey.Semin@baikalelectronics.ru
Signed-off-by: Serge Semin <Sergey.Semin@baikalelectronics.ru>
Reviewed-by: Rob Herring <robh@kernel.org>
Cc: Alexey Malahov <Alexey.Malahov@baikalelectronics.ru>
Cc: Paul Burton <paulburton@kernel.org>
Cc: Olof Johansson <olof@lixom.net>
Cc: linux-mips@vger.kernel.org
Cc: soc@kernel.org
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

show more ...